Model #13-300-M5 Goldblatt sprayer accessories

  • Electric Compressor With Pattern Pistol Gun And Hopper
    3 Results

Question and Answers

Q:

What does error 13 mean?

A:

The E: 13 is a drain pump issue (drain pump time exceeded). It may be a faulty drain pump, bad wiring, or a clogged drain hose.

I have included a set of illustrated instructions (See below). These should step you through the process of examining the drain pump and its components.

This is a very labor intensive do it yourself project, if you are not completely confident in your repair skills, I recommend calling a service company to diagnose and repair your appliance.

If you need more assistance please resubmit question with more details. I will be looking forward to helping you again in the near future.

Note: Our imaging system is malfunctioning. I would like to apologize in advance if the attachments do not appear online.

Read More
Landell -
Sears Technician
December 28, 2009
Q:

kenmore 300 broken

A:

Hi Alice,

Thank you for submitting a question to Manage My Life. I know how frustrating it can be when appliances do not function properly.

From what you have described you most likely have a bad water level switch (part number W10339334). Here is a video that will demonstrate gaining access to the inside of the console; Video .

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Here is a link that you may use to view the parts list diagram and for parts purchases; Sears Parts Direct .

I hope this is helpful. If I may be of further assistance as more details become available, please reply to this post.

Thanks again for using Manage My Life.

Landell

Read More
Landell -
Sears Technician
September 25, 2011
Q:

Kenmore 300 model 110.28322700

A:

Thank you for your question and I understand your concern.

Based on your symptom and details there could be some type of garment stuck inside the drain pump preventing the motor from running. I recommend removing the drain pump and then see if the motor will operate. The drain pump is easily taken loose from the motor and you can leave the two hoses attached. The washer cabinet will need to taken off from the base. NOTE: The motor will not run unless the lid switch is connected and closed. I added a YouTube video showing how to remove and replace the drain pump if you feel confident in repairing your washer. If the motor will not run without the drain pump connected then it could have a loose red or yellow wire connection at the motor or at the timer. If one of the red wires is loose on the start capacitor it would also cause the motor to just hum and not start.

Disconnect the power cord from the power source before servicing your washer.

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Read More
Joey S -
Sears Technician
December 05, 2011