Model #1-30-NOPT6 SUPERIOR Water heater, Gas

  • Round Gas
    3 Results
Find part by diagram >

Question and Answers

Q:

5303935203 we received 3 pieces of adhesive backed foil with the glass for the oven door. 1 is 1" by 30" and 2 are 4" x 8". What do I do with them???????

A:

Thank you for your question and I understand your concern.

I added an image below of where the foil should be installed. It will stick to outer side of key#6 between the key# 6 and the outer door glass. The 1" x 30" piece will fit along the bottom and the 2" x 4" will fit one each side as illustrated in the image below. Make sure it does not when looking through the outer door glass.

I hope this is helpful. If I may be of further assistance as more details become available, please reply to this post.

Read More
Joey S -
Sears Technician
July 06, 2012
Q:

I have a Kenmore 30" radiant slide-in range flashing F 1. Is the oven control board out? Is it okay to use the cooktop?

A:

The F1 fault code indicates either a stuck key on the touchpad or a failed transistor inside the electric range control (ERC). Either one would require replacing the ERC. The part number for the erc is WB27k5140R and the cost is around $160.00.

The cooktop should continue to work and it is safe for you to use it.

Read More
Jimmy K -
Sears Technician
April 23, 2008
Q:

Why does my Kenmore dryer model 110.76914693 complete 1 dryer cycle and then require 30 minutes to cool down before starting it again?

A:

The disassembly procedure for this type of dryer is shown in the images below. Be sure that you unplug the dryer and shut off the gas supply before beginning this process. You may find lint build-up around the motor that is preventing it from cooling properly. You could also have a bad bearing in the motor that is preventing it from continuing to run properly.

Read More
Lyle W -
Sears Technician