Model #130200 TO 130299 (1630-1939) Briggs & Stratton engine

  • Cylinder Head/crankcase/gearcase
    3 Results
  • Cylinder/flywheel/oil Switch
    3 Results
  • Housing-blower/clutch
    3 Results
  • Carburetor
    3 Results
  • Air Cleaner Assembly
    3 Results
  • Starter-rewind/tank-fuel
    3 Results
  • Muffler - Exhaust
    3 Results
  • Motor-starter
    3 Results

Question and Answers

Q:

Where can I find the instructions to a new Bissell Carpet Machine Plus Model 1630 carpet cleaner?

A:

The model number and description of this machine indicate that it is from 1988 to 1990. I do not find an owner's manual available in our online system for this item. I also do not find the owner's manual available on the Bissell website. I called Bissell. They indicated that that the owner's manual was no longer available. They also indicated that the owner's manual for model 1631 was the same as your model. Here is a link for the Bissell model 1631 carpet cleaner: Owner's Manual

Read More
Lyle W -
Sears Technician
August 12, 2009
Q:

My Kenmore Elite won't start

A:

You could have a problem with the door switches or the door latch assembly that is preventing the dishwasher from starting. The image below shows information about the door latches that are on the models of Kenmore Elite dishwashers that begin with 630.1630 . . . and 630.1730 . . . You can shut off the house circuit breaker for the dishwasher and check the door latch assembly and the switches for problems. That may help you determine the cause of this failure.

You can view and order parts on this page: Kenmore Elite Dishwasher Parts . Use the full model number to view parts for your exact dishwasher.

These initial tips may help you with that dishwasher problem. If you need more assistance, reply with additional details and the full model number of your dishwasher.

This is a fairly complicated dishwasher to diagnose and repair. If you get to the point where you need to have a service technician examine the dishwasher and fix this problem, you can schedule service through this link: Sears Home Services .

Read More
Lyle W -
Sears Technician
August 02, 2012
Q:

Why won't the gas valve open, the ignitor will glow and fade back off?

A:

Based on your details both solenoid coils need to replaced. Whenever you find the glow bar ignitor glowing red and then fading back off without any burner ignition would indicate a weak solenoid. When cold they will normally open the gas valve but once energized they become warm with current and will no longer have enough magnetism to open the valve. See images below.

I recommend replacing both coils at the same time. Order the coil kit part # 279834.

I added a link to Sears Parts Direct with the coil kit looked up for you.

Read More
Joey S -
Sears Technician
August 31, 2009