Model #12-2299-00-04 TAPPAN Wall Oven, Gas

  • Cover Page- Text Only
    3 Results
  • Control Panel
    3 Results
  • Gas Control
    3 Results
  • Door Parts
    3 Results
  • Broiler Drawer Parts
    3 Results
  • Body Parts
    3 Results
Find part by diagram >

Question and Answers

Q:

Why does the new door gasket for my LG washer model WM1832CW have holes in the 12:00 & 6:00 positions even though my old one does not?

A:

The gasket for this washer changed on models produced after September 20, 2007. According to your details, I assume that the serial number of your washer begins with numbers less than 709KW******* (i.e. 702KW1234567). Washers of this model produced before September 20, 2007 had the gaskets without the drain holes.

The original gasket that did not have holes is part number 4986ER0001A (only the last letter changes from C to A). If you order this gasket, it should not have the drain holes that the new gasket part 4986ER0001C has.

I recommend that you try ordering the gasket 4986ER0001A to resolve this problem. If that gasket does not fit, then you will likely need original gasket 4986ER0001B that some technical information indicates will fit this model of washer.

If neither of those parts work then you can replace the whole tub cover assembly by ordering part 3551ER0003C. Using all of the parts in this assembly would resolve your problem with incompatible parts. This assembly has the new gasket and the new tub cover that match. If you replace the whole tub cover assembly then you will likely need to replace the counterweights (part 4866ER0004A) since this new counterweight part will have a notch that will not interfere with the drain in the new tub cover.

If you need more help, resubmit your question with additional details and the full serial number of your LG washer.

NOTE: Special tools (pliers 383EER4001A and 383EER4004A) are normally needed to properly remove and replace the gasket on this type of washer. You may consider having a service technician replace the gasket instead of buying these tools that you would likely only use one time. Here is the link for the Sears Service website in case you need it: Sears Home Services .

Read More
Lyle W -
Sears Technician
January 28, 2010
Q:

What does the selector knob say when in the 12:00 position on a Kenmore 417 electric dryer?

A:

NORMAL cycle would be considered the 12:00 position on the type of dryer that you are describing. You may need the information in the tech sheet shown below. This sheet has technical information and tests for dryers with a digital display.

Be careful when using this technical information. Follow electrical safety guidelines. Unplug the dryer before accessing any internal components.

If you need more help, resubmit your question with additional details.

Read More
Lyle W -
Sears Technician
May 05, 2009
Q:

changed panel control at Jenn air electrical range. Put power back and only shows the time 12:00??

A:

Thank you for your question and I understand your concern.

When you stated that your changed the control panel with the active overlay I must assume you connected the ribbon connector properly to the oven control board.

I provided an image below showing how to test the control panel. If it tests Okay then I must assume the control board is faulty. You will need an ohm meter to test each button/switch.

NOTE: Be sure to disconnect the power cord from the power source before servicing the range.

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Read More
Joey S -
Sears Technician
March 30, 2011