Model #12-1863-00-02 TAPPAN range (gas)
Question and Answers
Why does the new door gasket for my LG washer model WM1832CW have holes in the 12:00 & 6:00 positions even though my old one does not?
The gasket for this washer changed on models produced after September 20, 2007. According to your details, I assume that the serial number of your washer begins with numbers less than 709KW******* (i.e. 702KW1234567). Washers of this model produced before September 20, 2007 had the gaskets without the drain holes.
The original gasket that did not have holes is part number 4986ER0001A (only the last letter changes from C to A). If you order this gasket, it should not have the drain holes that the new gasket part 4986ER0001C has.
I recommend that you try ordering the gasket 4986ER0001A to resolve this problem. If that gasket does not fit, then you will likely need original gasket 4986ER0001B that some technical information indicates will fit this model of washer.
If neither of those parts work then you can replace the whole tub cover assembly by ordering part 3551ER0003C. Using all of the parts in this assembly would resolve your problem with incompatible parts. This assembly has the new gasket and the new tub cover that match. If you replace the whole tub cover assembly then you will likely need to replace the counterweights (part 4866ER0004A) since this new counterweight part will have a notch that will not interfere with the drain in the new tub cover.
If you need more help, resubmit your question with additional details and the full serial number of your LG washer.
NOTE: Special tools (pliers 383EER4001A and 383EER4004A) are normally needed to properly remove and replace the gasket on this type of washer. You may consider having a service technician replace the gasket instead of buying these tools that you would likely only use one time. Here is the link for the Sears Service website in case you need it: Sears Home Services .
What does the selector knob say when in the 12:00 position on a Kenmore 417 electric dryer?
NORMAL cycle would be considered the 12:00 position on the type of dryer that you are describing. You may need the information in the tech sheet shown below. This sheet has technical information and tests for dryers with a digital display.
Be careful when using this technical information. Follow electrical safety guidelines. Unplug the dryer before accessing any internal components.
If you need more help, resubmit your question with additional details.
I am getting a F7 02 code on my kenmore electric range model # 790.4661. I have read many of the questions and answers but still need help.
I understand your concern and since you have already replaced the Oven Control/Clock Timer and it' still displaying the fault codes we can assume the failure is likely the touch panel.
The "F701" fault code is likely caused by a loss of a keyboard tail connection.
The "F702" fault code is likely caused by a shorted keypad.
Since the Electronic Oven Control (EOC) has been replaced, the failure is likely the Glass Touch Panel providing you do not have a loose keyboard tail connection.
If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services