Model #117-078 CENTURY Welder

  • Panels And Motor
    3 Results
Find part by diagram >

Question and Answers

Q:

Refrigerator G.E Profile model psi23ngmdww, light bulbs stayed on.

A:

The refrigerator light staying on in this type of GE refrigerator is normally caused by a bad light switch in the refrigerator. Replacing that part should fix this problem. You can order a new light switch from the Sears PartsDirect website. The part number for that switch is WR23X10530.

The switch is shown in the image below. Unplug the refrigerator before replacing this switch. You should be able to carefully pry the switch out and access the wires that are connected to it. There should be enough slack in the wiring going to the switch so that you will be able to unplug the wires. You can disconnect the wires and attach the wires to the new switch. Push the new switch into place and plug in the refrigerator. Test the new switch to make sure that it is working properly.

This information should help you fix this refrigerator problem. If you need more assistance, reply with additional details.

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Read More
Lyle W -
Sears Technician
May 06, 2011
Q:

My Craftsman garden tractor model917.276911 has recently started smoking

A:

I will need some more information to determine what is causing your engine to smoke.

Is the smoke white, black, or blue?

Does the tractor only smoke when it is first started? Does it smoke all the time? Does it smoke only when it is under a load?

Have you changed the oil recently?

Have you cleaned or replaced the air cleaner?

Many things can cause an engine to smoke. If you will answer these questions in another email, we will try to narrow down the possibilities for you. The only filter that will cause the engine to smoke is the air cleaner.

Read More
Jimmy K -
Sears Technician
May 27, 2010
Q:

The rail on my new garage door opener is too long. How do I shorten it?

A:

You would have to shorten the rail 7-8 inches. You can cut the rail on the back side where the 3 holes are. You can only remove one hole. The other 2 holes are required so the rail will interlock properly. You would also have to cut an equal amount off the tapered end of the rail so it will slide into the shortened rail fully.

You will also have to remove links from the chain to shorten it accordingly.

This is a lot of work and you might want to get an installation crew to install the garage door opener.

Read More
Jimmy K -
Sears Technician