Model #11629914900-1980 Kenmore vacuum, canister

  • Vacuum Cleaner And Attachment Parts
    3 Results

Question and Answers

Q:

11629914900 vaccum handle issues not attaching well --?why

A:

I am not sure what type of issues that you are having with that handle. The service information in the image below may help you. Be sure that you have the vacuum cleaner unplugged when accessing internal components.

If you need more help, reply with additional details and we will try to assist you further.

Read More
Lyle W -
Sears Technician
March 03, 2012
Q:

Kenmore 1980 (?) era washer

A:

Hi Sherre',

Thank you for submitting a question to Manage My Life.

I am sorry you are having problems with your washer.

From your description I recommend that you check the drain pump and drain hoses for clogs or blockage. Always unplug or de-energize electrical equipment before removing covers or attempting service. Be careful and wear appropriate hand protection when working around sharp metal parts. If you have a wet/dry vacuum you can use it to empty the water, otherwise you will have to bail the water out of the washer. You will then have to lay the washer down to get to the drain pump underneath. Check and see if there are any blockages in the hoses or openings in the pump.

Here is a link that you may use for parts purchases Sears Parts Direct .

The remaining checks will require the use of an ohm/volt meter. If you have a meter and are confident in your ability to safely perform these checks, reply to this post and I will be happy to assist you in any way I can.

I highly recommend having a trained service technician evaluate this problem. You can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Thanks again for using Manage My Life.

Landell

Read More
Landell -
Sears Technician
June 14, 2011
Q:

1980's craftsman band saw. buzzes when switched on, but will not run.

A:

Thank you for your question.

I can understand your concern when the band saw will not run.

Without the model and brand I can only give you some general things to try.

If I understand you correctly, you are saying that when you turn the band saw switch on the motor just hums.

• If this saw has an exposed drive belt from the motor, roll the drive belt off the pulleys and then turn the saw on again to see if the motor will run on its own.

• If the motor runs ok then you will need to turn the lower wheel over by hand to see if you can find where the resistance is. It could be a bearing in one of the wheels.

• If the motor will not run on its own, then the motor will have to be replaced.

• Remove the blade so you can isolate the upper and lower blade pulleys to see if one of those bearings could be the problem.

I hope these suggestions will help in diagnosis of the band saw.

Thank you for using Manage My Life.

Read More
Sam A -
Sears Technician
November 02, 2010