Model #11329441 Craftsman saw radial

  • Unit
    3 Results
  • Saw Guard And Yoke Assembly
    3 Results
  • Motor Assembly
    3 Results
  • Fence And Base Assembly
    3 Results

Question and Answers

Q:

Craftsman radial arm saw; model# 11329441

A:

Thank you for your question.

Having the carriage tight on your saw is critical.

I am not sure as to which area you are referring too.

Is it the pivot lock on the yoke clamp for the crosscut to the rip or the compound bevel lock?

I have e-mailed you the manual just incase you didn't have one and on the bottom of page 10 and on page 11 it addresses the lock adjustments for wear.

I hope this will help.

Thank you for using Manage My Life.

Read More
Sam A -
Sears Technician
December 11, 2010
Q:

Just answer the questions there 11329441 Craftsman Craftsman accra-arm 10 in. radial saw

A:

Thank you for your question.I am sorry you are having a problem with the radial arm saw. If the carriage has play in it, I recommend adjusting the carriage bearings on the side of the carriage. I posted an image below that shows how to adjust the bearings. Just click on the image to enlarge it. If you do not see the image, please copy and paste the following link in your address bar. http://www.managemylife.com/mmh/questions/338391-answer-questions-11329441-craftsman-craftsman-accra-arm-10-radial. Adjusting them should take the play out.  I hope this is helpful.  Please let me know if you need further assistance.   Thank you for using Manage my life. Mark T.  

Read More
Mark T -
Sears Technician
March 19, 2013
Q:

I need a wiring diagram for my radial arm saw #11329441. I am trying to replace the on/off switch #37874 and need to know how to wire it.

A:

Thank you for your request for a wiring diagram for the radial arm saw.

I will send you a wiring diagram for the saw below.

I hope this will help you wire the replacement switch.

Please let me know how it went.

Sam A.

Read More
Sam A -
Sears Technician
April 20, 2012