Model #112 Schwinn cycle

  • Cycle
    3 Results

Question and Answers

Q:

electrical diagram 106.51143 112

A:

I sent you an email with the information you're looking for. Look on page 5-13 for the pin connections and color of wires.

Read More
Joey S -
Sears Technician
November 10, 2014
Q:

I need to replace the drive mechanism of my Craftsman #112 29960 table saw.

A:

Thank you for your question about the arbor for the table saw.

The model for the saw is 113.29960.

The arbor shaft and bearing is available for ordering.

I will give you the direct link to this part.

Arbor shaft and bearing for table saw .

Part list breakdown for table saw .

I hope this will help.

Sam A.

Read More
Sam A -
Sears Technician
February 17, 2012
A:

Thank you for your reply. I do not believe the model number on your table is a 112. I think you may have miss-read it. If it is 112 then we do not have any parts for that tool. The 112. source was made by Parks wood working machines and is very old and the numbers after the dot would not have been that long a series. So I am pretty sure it is the 113. source you have. Sam A.

Read More
Sam A -
Sears Technician
February 18, 2012
See more answers
Q:

how do I clear a stopped up drain hose, model 48102

A:

Information on the drain pump and drain line is shown in the image below. Unplug the washer and remove the bottom front service panel to access the drain pump and drain hose. Your pump and the connecting hoses may look slightly different than the one shown below but the access procedure is the same. Arrange towels and/or a shallow pan to catch the water that will drain from the system when you disconnect the hoses. Disconnect the drain hose and the hose between the tub and the pump to clear out any residue. You should find a pump filter in the coin trap between the tub and the pump. After clearing out the debris from the drain system, reassemble the washer and test it.

If you need more help, submit additional details and we will assist you further.

Read More
Lyle W -
Sears Technician
August 10, 2010