Model #11-1553-45-04 TAPPAN ranges, electric

  • Cover Page
    3 Results
  • Backguard
    3 Results
  • Door Parts
    3 Results
  • Oven Body Parts
    3 Results
  • Door Parts
    3 Results

Question and Answers

Q:

Why is the ice maker leaking on my Kenmore refrigerator?

A:

According to your details, you indicated that the ice maker is leaking water on the floor when the unit is turned on. This symptom suggests that the leak is likely in the water tubing between the water valve and the ice maker module. I recommend unplugging the refrigerator and checking the water supply tubing from the water solenoid valve to the connection on the top of back outside refrigerator panel where it enters the freezer compartment. You will need to pull the bottom cardboard service panel off to access the solenoid water valve. If you find a leak in this water supply tube, then it will need to be replaced. This should fix your leaking problem.

If you need more help, resubmit your question with additional details.

Read More
Lyle W -
Sears Technician
November 03, 2008
Q:

Any one with the same problem with samsung washing machine WF448AAP/XAA 04

A:

I researched that part. The bottom portion of that dispenser housing is only available as a complete dispenser housing assembly (part DC97-14522A). Here is a direct link for that part: Dispenser Housing for Samsung Washer WF448AAP/XAA 04 .

Read More
Lyle W -
Sears Technician
March 24, 2012
A:

Let us know if that part fits properly if you get the chance. Let us know if you need more help.

Read More
Lyle W -
Sears Technician
March 26, 2012
See more answers
Q:

what does f 11 mean on your washer mean

A:

Thank you for your question.

The FdL and F11 fault code indicates that you have a problem with the door lock assembly or motor control communication to the main control. A failed door lock often causes this but it can also be caused by a failed wiring harness connection or in some instances by a failed control board.

Check for damage to the door hook on the washer door and look for anything that could be clogging the catch on the door lock assembly on the front panel of the washer.

You may need to check the wire harness connections on the door lock assembly, main control, and the motor control. The images below show the procedure for accessing the door lock assembly, main control, and motor control on this type of washer. Be sure that you unplug the washer before accessing internal components.

I have seen the failure be caused by a door lock and a faulty machine control board. A little trick I have found is to remove the top of the washer and push down lightly on the connector that is labeled dls5 this connector should have four black wires. This connector is located on the machine control board under the top. Use an insulated screwdriver to push on the connector and start a cycle. If the door locks, I recommend replacing the machine control. It has a bad solder joint on the board. We often see error code F11 also with bad solder joints on the control board. If pushing on the connector did not make a difference, I would suspect a faulty door lock first.

If you need further assistance, please add more details below.

Here is a link to order any parts you need. Sears Parts Direct .

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Thank you for using Manage my life. Mark T.

Read More
Mark T -
Sears Technician
February 14, 2011