Model #11092281800 KENMORE Residential Washers

  • Top And Cabinet
    3 Results
  • Control Panel
    3 Results
  • Rear Panel
    3 Results
  • Agitator, Basket And Tub
    3 Results
  • Miscellaneous
    3 Results
  • Brake, Clutch, Gearcase, Motor And Pump
    3 Results
  • Machine Base
    3 Results
  • Wiring Harness
    3 Results
  • Water System
    3 Results
  • Gearcase
    3 Results
Find part by diagram >

Error Codes

Error Code:



Question and Answers


Need to Replace Parts for the Top Agitator Auger 11092281100 Kenmore Automatic washer


Water on the floor 11092281800 Kenmore Automatic washer


Won't spin, won't drain 11092281800 Kenmore Automatic washer


There are a few troubleshooting tips that I can give you. This washer has a timer and a motor controller. There is a chance that the timer is stalling. You can try this first. If the timer stalls in spin and does not advance, try to manually advance the timer and restart the washer. You may also try to completely disconnect electrical power for a few minutes. After reconnecting power, the washer may resume spin operation. If this is happening, you may need a new motor control board or timer. A technician will be needed to diagnose and repair this type of failure.

You could also have loose wiring connections or a failed motor component that could cause this problem. If you are able to safely disassemble and access the drive motor, you may be able to check for loose wiring connections. NOTE: If you attempt this procedure, follow electrical safety guidelines. Completely disconnect electrical power to the washer before accessing internal components. Internal metal edges can be sharp. Protective gloves are recommended. Check the wiring connections from the motor control board to the drive motor for loose or broken wires. If you do not find any wiring problems, you may have a bad motor control board or drive motor. You will need a service technician to diagnose and repair this type of failure.

You may also have a drain problem. Check your drain hose for clogs or kinks. Check your drain configuration for compliance with the installation instructions of the washer. When the washer is draining properly, you should see a full circle of water flowing from the drain hose when the washer has water in it. If the washer is not draining properly, you may have a clog or your drain pump has failed. If you cannot find and clear the clog or drain pump problem, you will need a technician to diagnose and repair this type of failure as well.

Read More
Sherman_G_Wallace -
Sears Technician
November 25, 2013

Top Parts

Recommended maintenance parts & accessories

Show 3 more
No more item to show