Model #11087872602 Kenmore Elite residential dryer

  • Top And Console Parts
    3 Results
  • Cabinet Parts
    3 Results
  • Bulkhead Parts
    3 Results
  • Door Parts, Optional Parts (not Included)
    3 Results

Question and Answers

Q:

how do i remove the pedestal from my kenmore elite washer/dryer

A:

Hi Arnold,

Thank you for submitting a question to Manage My Life.

The pedestals are attached to the bottom of the washer and dryer with screws. The links above contain the instructions for installing pedestals. You will need to follow these in reverse to remove the pedestals. Always unplug or de-energize electrical equipment before removing covers or attempting service. Be careful and wear appropriate hand protection when working around sharp metal parts.

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Here is a link that you may use to view the parts list diagram or to purchase any parts needed; Sears Parts Direct .

I hope this is helpful. If I may be of further assistance please reply to this post.

Landell

Read More
Landell -
Sears Technician
March 08, 2012
Q:

kw rating

A:

That dryer technically does not have a KW rating. When the motor is running and the heating element is on, it will probably be using around 6 KW. The heating element uses most of the power. It is rated at 5500 watts. It does not stay on constantly during the drying cycle. It will be on about 2/3 of the time when the load is wet. I hope that this information helps. If you need more assistance, let us know.

Read More
Lyle W -
Sears Technician
June 06, 2012
Q:

My Kenmore elite He3 Smartheat Quietpak4 dryer model #11087872602 will light up and make the sounds however; when i push start button the dryer will not run.

A:

If you hear a faint click when the start button is pushed and the dryer don’t start would be a good indication the thermal fuse has failed. In order to test the thermal fuse it will need to be disconnected and checked for continuity using an ohm meter. Disconnect the power cord from the power source and then remove the lower access panel in order to access the thermal fuse. The thermal fuse is located on the blower housing as show in the image I added below. Remove the lower access panel to access the thermal fuse. Be sure to disconnect the two wires connected to the thermal fuse before testing the thermal fuse for continuity. If the fuse is good then I recommend calling a service technician to diagnose and repair your dryer.

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Read More
Joey S -
Sears Technician
August 03, 2010