Model #11087562602 KENMORE Residential Dryer

  • Top And Console Parts
    3 Results
  • Cabinet Parts
    3 Results
  • Bulkhead Parts
    3 Results
  • Door Parts, Optional Parts (not Included)
    3 Results
Find part by diagram >

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

Ordered and ECB PN 8565244 for my dryer model # 1108756-2602. Need to know how to install it.

A:

Thank you for your question and I understand your concern.

I was not able to locate a video. I added an image below with the procedure of accessing and removing the user interface assembly. NOTE: Disconnect the power cord from the power source before removing the top panel.

I hope this is helpful. If I may be of further assistance as more details become available, please reply to this post. 

If you do not feel confident repairing this problem yourself, then you can have it repaired by a Sears technician. You can schedule service through this link: Sears Home Services.

 

Read More
Joey S -
Sears Technician
December 03, 2013
Q:

red and black wire hookup on a w10111606 front load dryer control board 11087562602

A:

Hello Mike. I looked up the technical information on your Kenmore Dryer Model 110.87562602. The wiring diagram is shown in the image below. You seem to be describing the heater relay with the black and red wires marked on that wiring diagram. Check for markings on the control board or the relay that show N.O. and COM. Connect the wires according to those markings if present. If you see no markings, then you can connect the wires as they were originally connected on the existing control board. 

 

If you are not certain how to connect those wires, I recommend that you have a service technician replace that control board.

 

If you need more help, let us know. 

Read More
Lyle W -
Sears Technician
June 14, 2013
Q:

kenmore dryer model number 11087562602 will not start. power light comes on when i press start button and hold for 1 sec it beeps and you here a click

A:

Thank you for your question and I understand your concern.

Based on your symptom and details the thermal fuse is likely faulty preventing the dryer motor from starting. The thermal fuse is part#3392519 and is available at Sears PartsDirect

The thermal fuse (key#40) is located on the blower housing (key#44) and it can be disconnected and tested with an ohm meter.

I added an image below with the instruction how to access the thermal fuse. Click on the word "tested" above to view the video on how to check the thermal fuse. NOTE: Disconnect the power cord from the power source before removing the lower access panel.

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Read More
Joey S -
Sears Technician
March 28, 2011

Top Parts