Model #11082980120 Kenmore residential washers

  • Top And Cabinet
    3 Results
  • Console Panel
    3 Results
  • Rear Panel
    3 Results
  • Agitator, Basket And Tub
    3 Results
  • Miscellaneous
    3 Results
  • Brake, Clutch, Gearcase, Motor And Pump
    3 Results
  • Machine Base
    3 Results
  • Wiring Harness
    3 Results
  • Water System
    3 Results
  • Gearcase
    3 Results

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

11082980120 dial only works manually -- why -- only goes into spin manually?

A:

Thank you for your question and I understand your concern.

If you're indicating the timer is not advancing at all, I would suspect a faulty timer or a loose wire connection in the timer motor circuit. Disconnect the power cord from the power source and place the console in the service position. Check for any loose wire connections connecting the little timer motor. There will be 2 wires coming out of the little timer motor. One wire may be connected to a quick disconnect and the other will likely connect to one of the terminals on the timer.

To place the console in the service position; remove the screw at the bottom of each end cap. Slide the console towards the front of the washer and lift. Hinge it over the back panel to access the timer. If all the wires are connected; I recommend replacing the timer. The part number of the timer is 3351119 and it can be ordered from Sears PartsDirect .

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Read More
Joey S -
Sears Technician
March 06, 2012
Q:

I have a Kenmore washer model #11082980120. It makes a humming noise when I try to start it.

A:

Hi Brandon,

Thank you for submitting a question to Manage My Life.

I am sorry you are having problems with your washer.

I assume the washer will not drain. Here is a video that will demonstrate how to gain access to the drain pump; Video . Always unplug or de-energize electrical equipment before removing covers or attempting service. Be careful and wear appropriate hand protection when working around sharp metal parts. You will need to check the drain pump and hoses for clogs. You did not mention where the humming was coming from, so I recommend trying to determine what area of the washer is humming.

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

I hope this is helpful. Check the things I have covered here and if I may be of further assistance as more details become available, please reply to this post.

Thanks again for using Manage My Life.

Landell

Read More
Landell -
Sears Technician
May 31, 2011