Model #11082873100 Kenmore residential washers

  • Top And Cabinet Parts
    3 Results
  • Console Panel Parts
    3 Results
  • Water System Parts
    3 Results
  • Rear Panel Parts
    3 Results
  • Agitator, Basket And Tub Parts
    3 Results
  • Miscellaneous Parts
    3 Results
  • Brake, Clutch, Gearcase, Motor And Pump Parts
    3 Results
  • Machine Base Parts
    3 Results
  • Wiring Harness Parts
    3 Results
  • Brake And Drive Tube Parts
    3 Results
  • Gearcase Parts
    3 Results

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

I have a kenmore heavy duty residential washer that will fill and agitate but not advance to drain and spin. Timer, possibly?

A:

Thank you for your question and I understand your concern.

If the timer is advancing through the agitation cycles then it's not likely a faulty timer. If you manually advance the timer to a drain and spin cycle and pull out the timer knob while the lid is shut and the motor is not coming on, I suspect a faulty or broken lid switch. If you listen carefully when lifting and lowering the lid, you should hear a faint click of the lid switch opening and closing. If you do not hear a faint click, the lid switch actuator or lid switch is broken or faulty.

If the timer is not advancing during agitation; it likely has a faulty timer.

To lid switch is mounted under the top with a couple of screws. In order to access and replace the lid switch, the washer cabinet will need to be taken off from the base. I added an image below showing how to remove the washer cabinet. NOTE: Disconnect the power cord from the power source before servicing.

The lid switch #279347 for Kenmore washer model 110.82873100 can be ordered from Sears Parts Direct.

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

I hope this is helpful. If I may be of further assistance as more details become available, please reply to this post.

Read More
Joey S -
Sears Technician
April 16, 2012
Q:

washing machine

A:

Thank you for your question and I understand your concern.

The link ALina F. provided in the first response will address that question which was answered by the expert Mark T.

Read More
Joey S -
Sears Technician
February 14, 2011
Q:

my kenmore washer wont start unless you hit the control panel 11082873100

A:

Thank you for your question and I understand your concern.

Based on your symptom and details it sounds like there may be a loose wire connection at the timer or water level pressure switch if the power cord is making a good connection. If there are no loose connections, it's likely a faulty timer. NOTE: Disconnect the power cord from the power source before placing the console in the service position. To place the control panel/console in the service position; remove the screw at the bottom front of each control panel end cap. Slide the control panel towards the front of the washer and then lift it up and hinge it over the rear panel. Check all the wire connections at the timer and water level pressure switch. Disconnect the timer harness connector and make sure all the wires are locked in deep enough to make contact with the timer terminal leads.

Check the things I have covered here and if I may be of further assistance as more details become available, please reply to this post.

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Read More
Joey S -
Sears Technician
January 14, 2013