Model #11082832100 KENMORE residential dryer

  • Top And Console
    3 Results
  • Cabinet
    3 Results
  • Bulkhead
    3 Results
  • Door
    3 Results
  • Pedestal
    3 Results

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

Is the Kenmore Elite dryer stackable on my washer?

A:

Yes, the dryer can be stacked on the washer. The stack kit part# for the color white is 8519492.

Read More
Joey S -
Sears Technician
July 02, 2008
Q:

Where is the control board located on my Sears electric dryer model number 11082832100?

A:

Before replacing the control board, see if the dryer heats on an air dry (no heat) setting. If it does, then this may indicate that the heating element is broken and that the L2 side is shorted to cabinet ground. This would cause the dryer to heat constantly whenever the dryer is running. If you suspect a broken heating element, you could verify this type of failure by unplugging the dryer and checking the resistance of the heating element with the wires removed. The normal resistance of the heating element would be between 7 and 13 ohms. If you measure resistance way out of this range, you will need to replace the heating element.

If the heating element is okay, then replacing the control board would likely fix your overheating problem. The procedure for changing the electronic control board is provided in the first image below. The part number for the control board is 8546219.

Read More
Lyle W -
Sears Technician
August 05, 2008
Q:

Where can I find instructions for replacing my dryer drum seals in Kenmore model 11082832100?

A:

The tear down procedure for this type of dryer is shown in the image below. Your dryer may look slightly different, but the procedure will basically be the same. Be sure to unplug the dryer before accessing internal components. Once you remove the drum, you can carefully remove the drum seal and attach the new one. You should have received high temperature glue to attach the new seal. Fold the new seal in half to determine the mid-point. Start by attaching the mid point and then carefully working the two sides of the seal around so that they meet at the opposite side of the mid-point.

If you need more help, resubmit your question with additional details.

Read More
Lyle W -
Sears Technician

Top Parts