Model #11078415820 KENMORE Residential Dryer

  • Bulkhead Parts
    3 Results
  • Top And Control Parts
    3 Results
  • Cabinet Assembly
    3 Results
Find part by diagram >

Error Codes

Error Code:



Question and Answers


Unit powers and heats. Drum does not spin.


I understand how important it is to change the belt on your dryer correctly. While you are waiting for an expert answer, I did manage to find a helpful link about a similar dryer. I hope my link is useful.

Read More
Joseph P. -
September 01, 2010

If you have the top panel off you will be able to see the belt on the drum if it has not come off. To access the drum & belt area you will need to remove the front panel. The front panel is secured to the side panels. Remove the screws holding the front to the sides & lift the front panel off the lower clips. Be careful of the door switch & timer wiring. Spread the side panels apart far enough to slip the new belt on. Please see the images provided below for more instructions. Remember to disconnect power to the dryer before attempting access. Belt; 3394652, $19.75

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

SAFETY NOTICE: Be sure to disconnect power to the appliance before performing any repairs. If you are not comfortable with doing any voltage checks that might be recommended, please contact your local service provider for repairs. Be aware that there could be sharp edges inside the appliance that could cause cuts or other injuries to yourself or others.

Read More
biker dave -
Sears Technician
September 02, 2010
See more answers

What are the current electrical requirements for Kenmore dryer model 110.78415820?


The dryer location will require a 30 amp breaker.

The first image below shows the terminal block. Each leg should have 120 volt to it. So at the terminal block you should read 120 volts from black to white and from red to white. Across black to red should be 240 volts. See the 2nd image.

When an electric dryer is running and heating the amps on the black wire for the motor and element both will be approximately 25-26 amps.

I hope this information helps you resolve your problem.

Read More
Fred M -
Sears Technician
March 21, 2009

Top Parts

Recommended maintenance parts & accessories

Show 3 more
No more item to show