Model #11072056100 Kenmore residential dryer

  • Console Panel
    3 Results
  • Cabinet
    3 Results
  • Bulkhead
    3 Results
  • Dryer Top
    3 Results
  • Burner Assembly
    3 Results

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

Why does my Kenmore dryer model 11072056100 sometimes not run?

A:

The wiring diagram and a drawing of the control board for this dryer are shown in the image below. I recommend unplugging the dryer and checking the connections between the control panel and the electronic control board. Based on your symptoms, you may find a loose connection.

You may have a difficult time diagnosing an intermittent problem. The second image below shows the diagnostic test for the console and the pin out check. You may be able to use this information to determine the cause of your failure. Use extreme care if you check the voltage in the console as described on this sheet. You should only perform the checks described if you are completely confident in your technical ability to safely perform the procedures. Making contact with live wires in the console could result in electrical shock.

These tips may help you determine whether you need to replace the console or the electronic control board (or neither one). If you need more help, resubmit your question with additional details.

Read More
Lyle W -
Sears Technician
September 10, 2009
Q:

How do I connect the wires to components on my Kenmore dryer?

A:

The wiring diagram for this model is the same that was previously sent. The thermistor does have the red/white and black wires attached to it. It does not matter which terminals the wires are attached to. The solid red wires should be attached to the thermal fuse. Again, the wires can be attached to either terminal on the thermal fuse.

If you need to raise the dryer up by placing it on a sturdy 12" platform, this should not be a problem. Make sure that the platform is stable. Make sure that the dryer is leveled properly once it is placed on the platform.

Read More
Lyle W -
Sears Technician