Model #1106958701 KENMORE Residential Dryer

  • Machine Sub-assembly
    3 Results
  • Bulkhead Assembly
    3 Results
  • Top & Console Assembly
    3 Results
Find part by diagram >

Error Codes

Error Code:



Question and Answers


I have a Kenmore dryer #1106958701w00 and I replaced the heating element. I was only able to get low heat from the element #337365 so I switched


It can be problematic sometimes when replacing parts. I understand the problem with the heating element, your expert will be able to do give a detailed answer. It may take 24-48 hours.

Read More
Marc H -
April 02, 2012

According to your model number, that is an older dryer. I found what I believe to be the wiring diagram for that dryer in the image below. That dryer heating element circuit is traced in red. You have one leg of 120 volt potential going through a timer and an operating thermostat that cycles to regulate the heat. The 2nd leg of 120 volts of opposite potential goes through the motor centrifugal switch and the high limit thermostat. Your details indicate that you may have bypassed that high limit thermostat. That could be why the dryer heating element is heating constantly now. I recommend that you restore the wiring to the original configuration and replace the cycling thermostat (part 694674). That component is on the blower housing. It will cycle the element on and off to maintain a temperature of about 140 to 150 degrees in the dryer. Be sure that you unplug the dryer before accessing internal components. Here is a link for that operating thermostat: Operating Thermostat for Kenmore Dryer 110.6958701 . If you need more help, reply with additional details.

Read More
Lyle W -
Sears Technician
April 04, 2012
See more answers

Top Parts

Recommended maintenance parts & accessories

Show 3 more
No more item to show