Model #11067062600 Kenmore Elite residential dryer

  • Top And Console Parts
    3 Results
  • Cabinet Parts
    3 Results
  • Bulkhead Parts, Optional Parts (not Included)
    3 Results

Question and Answers

Q:

Why is my Kenmore Oasis dryer model 11067062600 displaying the F40 error code?

A:

If the machine control board has not been replaced then the likely cause of this fault code would be the user interface control board.

You are correct in that this dryer does not have a motor control board since it does not have the separate blower motor. The F40 code normally indicates a failure in communication between the main machine control board and the blower motor control board. In some instances, a loose wiring harness connection or a failed user interface control board could produce signals that are interpreted by the main machine control board to indicate a blower motor control board communication error even though this component is not present in your model of Oasis dryer.

If you are able to unplug the dryer and safely access the components in the console, you can check the wiring harness connections on the machine control board. If you do not find a problem with any wiring connections (especially between the user interface and the main control board), then the user interface control will likely need to be replaced to fix this problem.

The procedures for access and replacing the control boards are provided in the image below. The image below shows a model with the motor control. As noted above, your model does not have this component.

If you need to replace the user interface control board, you can order it from the Sears PartsDirect website. The part number is 280157.

If you need more help, resubmit your question with additional details.

Read More
Lyle W -
Sears Technician
April 23, 2009
Q:

Kenmore elite oasis dryer error code model # 11067062600

A:

Thank you for your question and I understand your concern. Based on the model submitted, your dryer has only one motor and no motor control board. The "F40" fault code is likely displaying because if you have the right combination of bad diodes on the interface it can tell the control that it is a dual motor model when it is not.

I recommend checking for loose interface connections first. If all the connections are good, replace the Interface board. I added an image below with the replacement instructions.

The interface board is part #280157. You can order the interface board from Sears PartsDirect

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services

Read More
Joey S -
Sears Technician
January 26, 2011
Q:

How do I connect electrodes (yellow/black wire) on Oasis dryer model 11067062600 which I opened for cleaning?

A:

The wires that you are describing go to the moisture sensor. It does not matter which order the wires are attached to this component. The black and white photo below shows the order that these wires are normally attached. You can attach them in the order shown below (darker wire on the right is black). Even if they are reversed, it would not matter. The control board just senses the continuity through this circuit. Just make sure that the wires are reattached securely.

If you need more help, resubmit your question with additional details.

Read More
Lyle W -
Sears Technician
October 07, 2009