Model #11062882101 Kenmore residential dryer

  • Cabinet Parts And Optional Parts (not Included)
    3 Results
  • Top And Console Parts
    3 Results
  • Bulkhead Parts
    3 Results

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

not heating 11062882101

A:

Thank you for your question and I understand your concern.

The heating element requires 220-240 volts in order to heat. If the heating element is not broken in two, and the thermal cut-off and high limit thermostats measure continuity, then I would suspect a faulty even heat control board or possibly a faulty heater relay. The heater relay and even heat control is located in the control panel. In order for the Line One (L1) voltage supply to make it to one lead of the heating element, the even heat control board must provide 48 volts DC to the heater relay. The heater relay must close in order to complete the L1 voltage supply to one lead of the heating element. The DC voltage supply will need to be checked at the heater relay across the two red wires with the white stripe and the heater relay once you start the dryer. If you do not measure 48 volts DC, the control board is most likely faulty. If you do measure 48 volts DC, the heater relay is faulty and not closing in order to complete the L1 voltage page to the heating element. If the motor centrifugal switch fails to close contacts 2M to 1M once the motor starts, the heater will not heat because the lack of Line Two (L2) voltage. I added an image of the wiring diagram in the second response in the thread. NOTE: I do not recommend measuring any voltages unless you have experience and feel safe and confident in doing so; otherwise I recommend calling a service technician to diagnose and repair your dryer.

I hope this is helpful. If I may be of further assistance as more details become available, please reply to this post.

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Read More
Joey S -
Sears Technician
February 06, 2013
A:

Casey: If the image above is too small, see the image below.

Read More
Joey S -
Sears Technician
February 06, 2013
See more answers
Q:

Where can I find a belt installation diagram for my Kenmore dryer model 11062882101?

A:

Here is a link for a picture that shows the routing of a dryer belt through a slide assembly: Slide Assembly

The belt goes through this type of assembly in a similar manner to the wheel type idler pulley. The wheel type is shown in the image below.

This should help you properly route your dryer belt.

If you need more help, resubmit your question with additional details.

Read More
Lyle W -
Sears Technician
June 15, 2009