Model #11062212101 KENMORE residential dryer

  • Cabinet
    3 Results
  • Top And Console
    3 Results
  • Bulkhead
    3 Results

Error Codes

Error Code:



Question and Answers


i need a picther on how to put a drive belt on my dryer


Thank you for your question.

I should be able to help you replace the belt on your dryer. First, you need to unplug the dryer and put on a pair of gloves. The inside metal parts of the dryer can be sharp. Then follow the steps below.

  • Remove the lint screen.
  • Remove the two screws in the top under the screen.
  • Pull the top forward to clear the two clips along the front. Then lift the top.
  • Remove the two screws securing the front panel.
  • Unplug the door switch harness and remove the front panel.
  • Lift the drum out of the cabinet and clean the inside of the cabinet with a vacuum.
  • Place a few drops of light oil on the roller shafts before reassembly.

I have also added a few images below, showing the steps for replacing the belt.

If you would like to watch a video showing how to replace the belt please click on this link .

If you run into problems, please reply below and I get right back to you.

Here is a link to order any parts you need. Sears Parts Direct .

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Thank you for using Manage my life.

Mark T.

Read More
Mark T -
Sears Technician
September 10, 2011

The heating element seems to get hot but there is no lint in the trap 11062212101 Kenmore Electric dryer


Thank you for your question and I understand your concern.

If the dryer will start and run, the fan is running. The fan/blower wheel is connected directly to the back side of the motor. If the dryer is running and heating but takes a long to time dry, this is usually caused by a blocked or restricted venting system or vent hose. For testing purposes only; pull the dryer out from the wall and disconnect the vent hose from the exhaust. Start the dryer and you should feel a lot of air blowing out. If you do, then check the vent hose for kinks or restrictions. Check the vent cap also where the dryer vents outside and make sure the vent flapper is opening.

You can also try drying one load of clothes while the vent hose is disconnected from the back of the dryer. If it dries in normal amount of time with the vent hose disconnected, this would definitely indicate a blocked or restricted vent system.

Check the things I have covered here and if I may be of further assistance as more details become available, please reply to this post.

Read More
Joey S -
Sears Technician
June 04, 2013

Why won't my Kenmore dryer timer work even after replacing it 3 times?


See if the timer advances in the timed dry or the auto dry cycles. If the timer advances in timed dry but not in auto dry, then you could have a wire connection failure in the orange wire from the heating element to the timer.

If the timer will not advance in either type of cycle, then I recommend checking the timer part number that you are using. I am showing that this model of dryer uses timer part 8299777. This should be a 230 volt timer with brown motor leads. It should be imprinted with "230VAC-60HZ". If you replaced the timer with a 120 volt timer (black leads to the timer motor), it will not advance.

These tips may help you determine the cause of your timer problem. If you need more help, resubmit your question with additional details.

Read More
Lyle W -
Sears Technician
November 04, 2008

Top Parts

Recommended maintenance parts & accessories

Show 3 more
No more item to show