Model #11049962602 Kenmore Elite residential washers

  • Top And Cabinet Parts
    3 Results
  • Door And Latch Parts
    3 Results
  • Control Panel Parts
    3 Results
  • Dispenser Parts
    3 Results
  • Tub And Basket Parts
    3 Results
  • Pump And Motor Parts
    3 Results
  • Optional Parts (not Included)
    3 Results

Question and Answers

Q:

Water level switch

A:

Thank you for your question and I understand your concern.

The water level pressure switch is located in the top right rear corner of the washer. You will have to remove the top in order to access it and the pressure switch hose. You can disconnect the hose and blow through the hose to check for a blockage.

I added an image below with the information needed to check the pressure switch with an Ohm meter. NOTE: Disconnect the power cord from the power source before removing the top.

I hope this is helpful. If I may be of further assistance as more details become available, please reply to this post.

Read More
Joey S -
Sears Technician
August 24, 2011
Q:

washer model # 11049962602 showing f22 code the spin seems slow and often times the clothes are still very wet when cycle is done

A:

Thank you for your question and I understand your concern.

The "F22" fault implies a faulty door lock assembly. Possible Causes/Procedures:

  • Door lock mechanism is broken.
  • Door switch/lock unit is faulty.

Unplug the washer or disconnect the power and check door switch/lock unit. Check the wire harness connections to the door switch/lock unit and Central Control Unit (CCU). The CCU is located under the top on the upper side of the panel.

If there is nothing apparently broken or any loose or disconnected wires in the door lock circuit, I recommend replacing the door lock assembly. The door lock #8183270 for Kenmore washer model 110.49962602 can be ordered from Sears Parts Direct.

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Read More
Joey S -
Sears Technician
April 18, 2012
Q:

I purchased a new outer rear tub because mt bearings went bad and now the spindle on my existing inner drum does not fit through to the second set of bearings. 11049962602

A:

Thank you for your question and I understand your concern.

If the spin basket shaft slid through the first bearing it should slide through the second bearing unless the bearing is out of round or too small. Make sure the spin basket shaft is not flared out, this could also prevent the shaft from sliding through the second bearing. You could possibly have a faulty bearing in the new rear tub assembly if your certain the bearing is too small.



Read More
Joey S -
Sears Technician
April 01, 2014