Model #11042822202 KENMORE ELITE residential washers

  • Top And Cabinet
    3 Results
  • Door And Latch
    3 Results
  • Control Panel
    3 Results
  • Dispenser
    3 Results
  • Tub And Basket
    3 Results
  • Pump And Motor
    3 Results
  • Pedestal Parts (not Included)
    3 Results

Question and Answers

Q:

My Kenmore elite washer Model# 11042822202 will not start. when pushing any of the wash cycle buttons, the light blinks cont. and will not start.

A:

Based on your symptom and details it could have shook a wire connection loose on the machine control, interface, motor control board , motor or door lock assembly. The tub could have also struck the door lock assembly or the machine control board when it was shaking violently and has broken one of the two.

You could disconnect the power cord and then take the top, lower access panel and rear panel off and make a visual inspection of all the components and wiring to see if any wires have been pulled loose or if any components have been damaged. Based on your symptom you will likely have to have service technician diagnose the failure.

NOTE: Disconnect the power cord from the power source before removing any panels.

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Read More
Joey S -
Sears Technician
October 05, 2010
A:

Sheila: Based on your model, symptom and details; the "User Interfaceā€¯ is faulty or you have stuck button. Press and release each button and compare how they feel and react. If all the buttons seem to feel like they are springing back out when released then I would assume a faulty "User Interface". Note: There is no reset button. You could try disconnecting the power cord for a few minutes and then reapply power and see if starts. I recommend calling a service technician to properly diagnose and repair your washer.

Read More
Joey S -
Sears Technician
July 29, 2011
See more answers
Q:

My Kenmore Elite HE3 model #110-42822202 that will not fill with enouhg water. Only gets about 1 gallon of water, no flow restrictions. What should I do?

A:

That model of high efficiency washer does not fill with much water. The normal fill when empty is about 1.7 gallons. I recommend that start the washer with no clothes added. Once it is filled, checked the water level. It should be about 2 1/2" to 3 1/2" high (+/- 1/2") when measured at the very back of the tub. That tub tilts backward so it is important to measure that water level at the rear of the tub.

If the water level is too low, then the water level pressure switch may need to be replaced. Be sure that you unplug the washer before accessing and replacing internal components if you fix this problem yourself.

You can order parts from this page: Kenmore Elite HE3 Washer 110.42822202 Parts .

If you need more help, reply with additional details and we will assist you further.

If you get to the point where you need to have a service technician diagnose and repair this failure, you can schedule service through this link: Sears Home Services .

Read More
Lyle W -
Sears Technician
May 28, 2012

Top Parts