Model #11028692701 KENMORE Residential Washers

  • Top And Cabinet Parts
    3 Results
  • Control Panel Parts
    3 Results
  • Rear Panel Parts
    3 Results
  • Agitator, Basket And Tub Parts
    3 Results
  • Brake, Clutch, Gearcase, Motor And Pump Parts
    3 Results
  • Machine Base Parts
    3 Results
  • Wiring Harness Parts
    3 Results
  • Brake And Drive Tube Parts
    3 Results
  • Gearcase Parts, Optional Parts (not Included)
    3 Results
Find part by diagram >

Error Codes

Error Code:



Question and Answers


Very limited cold water intake on Kenmore washer model 110.28692701


Thank You for contacting

I can understand your frustration with the water taking so long to fill the tub. First I recommend unplugging the washer and shutting off the water. Disconnect the hoses from the back of the washer and put them into the washer tub. Turn on the water and check to see if the water is at full pressure. If the water is not at full pressure then shut the water back off and remove the hoses. Check the hose opening for a screen-filter, if the hoses are more than 3-5 years old, replace them.

If the water was at full pressure then the problem is going to be with the water valve. The water valve may not be opening up far enough. In this case the valve just needs to be replaced. I have included a link to our PartsDirect page where you can purchase the part you need to complete your repair. Just click the blue link below to be taken to the page.

Valve Assembly for Model 110.28692701

Nylong Braided Fill Hoses - 2 pack

If you have further questions please let me know.
Thanks for using


Read More
Desirea -
Sears Technician
September 08, 2013

Top Parts

Recommended maintenance parts & accessories

Show 3 more
No more item to show