Model #11027721600 Kenmore residential washers

  • Top And Cabinet Parts
    3 Results
  • Control Panel Parts
    3 Results
  • Rear Panel Parts
    3 Results
  • Agitator, Basket And Tub Parts
    3 Results
  • Brake, Clutch, Gearcase, Motor And Pump Parts
    3 Results
  • Machine Base Parts
    3 Results
  • Wiring Harness Parts
    3 Results
  • Brake And Drive Tube Parts
    3 Results
  • Gearcase Parts, Optional Parts (not Included)
    3 Results

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

kenmore washer model 11027721600

A:

Thank you for submitting a question to Manage My Life.

From your description this is most likely caused by a bad timer. The diagnosis of this issue will require the use of a volt/ohm meter. If you have a meter and are confident in your technical abilities please reply below and I will be happy to assist you further.

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website; Sears Home Services .

Here is a link that you may use to purchase the timer for your Kenmore model number 110.27721600 washer .

If you have a meter and are confident in your technical abilities please reply below and I will be happy to assist you further.

Landell

Read More
Landell -
Sears Technician
April 12, 2012
Q:

my machine rocks and periodically shuts off why ? i think by it rocking its opening the lid?11027721600-thanks

A:

Hi Ariel,

Thank you for submitting a question to Manage My Life.

This can be a hard problem to diagnose. The first thing I recommend is removing the cabinet and inspecting the base, and suspension. The suspension system consists of springs, friction pads, suspension plate, base and a balance ring. The balance ring is attached to the top of the spin basket and it should be about half full with a liquid. If the liquid has leaked out of the balance ring it will cause the tub to shake. I added an image below showing the suspension system. If the washer was moved incorrectly with a dolly the base can be bent slightly enough to weaken it and cause all the vibration and shaking too. It's very important that the washer is level and sitting on a solid foundation or it will vibrate and shake excessively also.

Here is a video that will demonstrate gaining access to the base and suspension on your washer; Video . Always unplug or de-energize electrical equipment before removing covers or attempting service. Be careful and wear appropriate hand protection when working around sharp metal parts. The washer in this video may not look exactly like yours, but the procedure is basically the same.

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Here is a link that you may use to view the parts list diagram or to purchase any parts needed; Sears Parts Direct .

I hope this is helpful. Check the things I have covered here, and if I may be of further assistance, include more details in a reply to this post.

Landell

Read More
Landell -
Sears Technician
February 06, 2012
Q:

Kenmore 700 series - Control Panel

A:

Thank you for your question and I understand your concern.

I added a YouTube video showing how to release and place the control panel in the service position. The video will show how to remove the cabinet in order to replace the drain pump but of course you will not need to replace the drain pump or remove the cabinet.

See image below for instructions on removing the water level switch. NOTE: Disconnect the power cord from the power source before placing the control panel in the service position.

Read More
Joey S -
Sears Technician
May 23, 2011