Model #11027082601 Kenmore Elite residential washers

  • Top And Cabinet Parts
    3 Results
  • Control Panel Parts
    3 Results
  • Motor, Basket And Tub Parts
    3 Results
  • Pump Parts, Optional Parts (not Included)
    3 Results

Question and Answers

Q:

Elite Oasys HE model 11027082601 no power

A:

Thank you for your question and I understand your concern.

I added three images below to reference. In the first image; I circled the three areas of concern. I circled two areas where the voltage comes in, and the other is the connection for the user interface. If the control board is getting the correct voltage, the user interface is likely faulty. You will need a voltage meter in order to check and verify the voltage supply. NOTE: I do not recommend making any voltage checks unless you have experience and feel safe and confident in doing so; otherwise I suggest calling a service technician to diagnose and repair your washer. If proper voltage is measured, I suspect a faulty user interface board. The user interface #8564392 for model 110.27082601 can be ordered from Sears Parts Direct.

Check the things I have covered here and if I may be of further assistance as more details become available, please reply to this post.

Read More
Joey S -
Sears Technician
September 26, 2012
A:

Robert: Thank you for using Manage My Life and I'm happy I was able to assist you in repairing your washer. Have a great day.

Read More
Joey S -
Sears Technician
October 12, 2012
See more answers
Q:

What does F1 mean on a top load Kenmore washer - Model 11027082601

A:

I see that Barbara H has given you a good link to the F01 error code. I have added the following information about the F01 error code.

The F1 fault code on this washer indicates that the water level pressure transducer signal is out of range. This can be caused by the pressure transducer air hose tubing being pinched or crimped. A failed pressure transducer on the machine control board can also cause it.

The first image below shows the method for accessing the pressure transducer tube that runs from the bottom of the washer tub to the machine control. I recommend checking this air hose for pinches, twists or crimps. NOTE: Be sure to unplug the washer to disconnect electrical power before accessing internal components.

If you find no problems with the pressure transducer tube, then the machine control board will need to be replaced. The procedure for accessing and replacing the machine control board is shown in the second image below. The part number for the machine control board is W10189966. You can order this part from the Sears PartsDirect website www.searspartsdirect.com .

Make sure to unplug the washer before attempting any repair of the washer.

If you need more help with this washer, please submit additional details.

Thank you for using Manage my life.

Here is a link to order any parts you need. Sears Parts Direct .

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Read More
Mark T -
Sears Technician
September 04, 2010
Q:

11027082601 machine lid won't lock the so the machine can start

A:

Thank you for your question.

I am sorry you are having a problem with your washer. The lid on your washer has a magnet that has to trigger the lid switch in the front of the washer. If the hinge is broken, it might not be closing the circuit on the lid switch. I have provided you with the instructions below for replacing the lid hinge. You should not have any problems replacing the hinge. The part number for the hinge is 8563964 and can be ordered from our parts website. Sears Parts Direct

I hope this id helpful. If you need further assistance, please reply below with more details.

Thank you for using Manage my life.

Mark T.

Read More
Mark T -
Sears Technician
November 19, 2010