Model #11026442503 Kenmore residential washers

  • Top And Cabinet Parts
    3 Results
  • Control Panel Parts
    3 Results
  • Rear Panel Parts
    3 Results
  • Agitator, Basket And Tub Parts
    3 Results
  • Brake, Clutch, Gearcase, Motor And Pump Parts
    3 Results
  • Machine Base Parts
    3 Results
  • Wiring Harness Parts
    3 Results
  • Brake And Drive Tube Parts
    3 Results
  • Gearcase Parts
    3 Results
  • Water System Parts, Optional Parts (not Included)
    3 Results

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

11026442503 over fills

A:

Thank you for submitting a question to Manage My Life.

A problem with the washer overfilling is usually caused by a failed water level pressure switch (part W10335056). A problem with the air tube connection could also cause this problem. You can unplug the washer and open the console as shown in the first image below. Check the air hose that goes to the water level pressure switch to make sure that it is connected properly. Check that hose for damage or leaks. If you need to pull the cabinet off of the washer and check the hose more closely all of the way to the bottom of the tub, you can use the procedure in this Video to remove the cabinet (with the washer still unplugged ). If you find no problems with the air hose, then the water level pressure switch will probably need to be replaced.

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website; Sears Home Services .

Here is a link that you may use to view the parts list diagram or purchase any parts needed for your appliance; Sears Parts Direct .

I hope this is helpful. Check the things I have covered here and if I may be of further assistance please reply to this post.

Landell

Read More
Landell -
Sears Technician
July 02, 2012
Q:

My washer is leaking some, but not all of the water out at some point during the wash cycle. I have checked the drain hose and there is no leak there. I'm ass

A:

Thank you for your question and I understand your concern.

In order to locate the source of the leak will require operating the washer with cabinet taken off the base. You will also need to connect the lid switch in order to operate the washer otherwise the motor will not operate.

The leak is likely emitting from the drain pump located at the front bottom center area of the washer. I added a YouTube video showing how to access and replace the drain pump .

I hope this is helpful. If I may be of further assistance as more details become available, please reply to this post.

Read More
Joey S -
Sears Technician
September 06, 2011

Recommended maintenance parts & accessories

Show 3 more
No more item to show