Model #11025852400 Kenmore residential washers

  • Top And Cabinet
    3 Results
  • Control Panel
    3 Results
  • Rear Panel
    3 Results
  • Agitator, Basket And Tub
    3 Results
  • Brake/clutch/gearcase/motor/pump
    3 Results
  • Machine Base
    3 Results
  • Wiring Harness
    3 Results
  • Water System
    3 Results
  • Miscellaneous
    3 Results
  • Brake And Drive Tube 388952
    3 Results

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

Kenmore 80 Series Washer

A:

Thank you for your question.

I will be happy to assist you. I looked up the model number you submitted. This washer is a 3.2 cubic foot model.
I hope this is helpful. If you need further assistance, please reply below.

Thank you for using Manage my life.

Mark.

Read More
Mark T -
Sears Technician
July 19, 2012
Q:

Kenmore washer won't agitate

A:

Hi Merle,

I know how frustrating it can be when appliances do not function properly.

By what you have stated, it sounds like a lid switch failure. The lid switch has to be functional, for the agitate, drain, and spin cycle to work on your washer. If the lid switch is faulty, it will fill and nothing else.

A quick check you can make is to bypass the lid switch and see if it will agitate. If the washer operates, the lid switch needs to be replaced.

To bypass the lid switch you need to unplug the washer and open the console. I have provided you with the instructions for opening the console in a video below. Once you have the console open, locate the connector for the lid switch. Place an insulated section of wire between the two colored wires. Not the green, it is a ground and will cause a short. After inserting the insulated section of wire make sure it will not touch anything metal, plug the washer in. Start the washer in a drain cycle. If the washer operates, you need to replace the lid switch. Do not leave the insulated section of wire in place while you are waiting for the part. This is only for the test.

To replace the lid switch you have to remove the cabinet of the washer. The instructions for that are also in the video below. Once the cabinet is removed you can take the screws out securing the lid switch and remove the harness from the clips along the underside of the cabinet. Then reinstall the lid switch in the reverse order.

Please click here to watch a video on how to replace the lid switch.

Here is a link that you may use to purchase the lid switch for this washer Lid Switch .

I hope this is helpful. If I may be of further assistance as more details become available, please reply to this post.

Thanks again for using Manage My Life.

Landell

Read More
Landell -
Sears Technician
May 10, 2011
Q:

washer repair

A:

Hello,

Thank you for submitting a question to Manage My Life.

I am sorry you are having problems with your washer.

Here is a video that demonstrates the process of replacing the lid switch on washing machines similar to yours; Video . Your washer may not look exactly like the one in the video, but the procedure is basically the same.Always unplug or de-energize electrical equipment before removing covers or attempting service. Be careful and wear appropriate hand protection when working around sharp metal parts.

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

I hope this is helpful. If I may be of further assistance as more details become available, please reply to this post.

Thanks again for using Manage My Life.

Landell

Read More
Landell -
Sears Technician
June 10, 2011