Model #11024432300 Kenmore residential washers

  • Top And Cabinet
    3 Results
  • Control Panel
    3 Results
  • Rear Panel
    3 Results
  • Agitator, Basket And Tub
    3 Results
  • Brake/clutch/gearcase/motor/pump
    3 Results
  • Machine Base
    3 Results
  • Wiring Harness
    3 Results
  • Water System
    3 Results
  • Miscellaneous
    3 Results
  • Brake And Drive Tube 388952
    3 Results

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

Washer stopped working after filling with water 11024432300 Kenmore Automatic washer

A:

Thank you for your question and I understand your concern.

Your specific model washer will not operate in order to agitate or spin and drain if the lid is open. If the lid is shut and the washer motor will not start, it most likely has broken or faulty safety lid switch.  The lid switch part #3949238 can be ordered from SearsPartsDirect.

 The lid switch is located under the top of the washer. In order to access and replace the lid switch will require removing the washer cabinet from the base. Before the cabinet can be taken off, the left and right hand end cap covers must the taken off. Lift the back upper rear edge of the end cap cover up and hinge it towards the front of the washer and remove it. You will see a screw at the bottom of the left and right hand end cap. Remove those two screws. Slide the control panel towards the front and lift it up and hinge it over the rear panel. Disconnect the lid switch harness connector from the top of the washer. You will see two gold colored cabinet clips securing the top of the cabinet to the rear panel. You need to pop the two clips off using a flat blade screwdriver. Place the tip of the screwdriver in the first valley closest to the front and then push the handle back to pop the clips loose. Remove the two cabinet clips. Open the lid and tilt the washer cabinet forwards and the walk it away from the washer. You now have access to the lid switch under the top to remove and replace. Reverse the procedure to install the new lid switch. NOTE: Disconnect the power cord from the power source before servicing.

I hope this is helpful. If I may be of further assistance as more details become available, please reply to this post. 

 

Read More
Joey S -
Sears Technician
March 13, 2013

Recommended maintenance parts & accessories

Show 3 more
No more item to show