Model #11024422300 Kenmore residential washers

  • Top And Cabinet
    3 Results
  • Control Panel
    3 Results
  • Rear Panel
    3 Results
  • Agitator, Basket And Tub
    3 Results
  • Brake/clutch/gearcase/motor/pump
    3 Results
  • Machine Base
    3 Results
  • Wiring Harness
    3 Results
  • Water System
    3 Results
  • Miscellaneous
    3 Results
  • Brake And Drive Tube 388952
    3 Results

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

Why won't my washer fill with cold water and only fills with hot water on model 11024422300?

A:

Thank you for your question and I understand your concern.

Since your washer does not have a water temperature switch; the Start position of the Timer will dictate the water temperature. For COLD wash you will need to start the timer at the 6 minute mark or short wash.

I added an image below showing where to set the timer for the appropriate water temperatures.

This may be the issue. If not, please reply and I will be glad to assist you further.

Read More
Joey S -
Sears Technician
September 03, 2011
Q:

How do I remove the cabinet from my Kenmore 11024422300 washing machine to find a leak?

A:

Thank you for your question and I understand your concern.

I added a YouTube video showing how to remove the washer cabinet. The video will also show how to replace the motor coupler but of course you will not need to replace the motor coupler. NOTE: Disconnect the power cord from the power source before placing the console in the service position.

Read More
Joey S -
Sears Technician
September 06, 2011
Q:

washer fills and does nothing else.

A:

Thank you for your question.

By what you have stated, it sounds like a lid switch failure. The lid has to be closed for the motor to on the washer. If the lid switch is faulty, it will act as if the lid is not closed. On this model, make sure the lid hinge screws are tight. If the screws are loose, the hinge might not activate the lid switch. A quick check you can do is to run a cycle with the lid switch jumped. If the washer operates, the lid switch needs to be replaced.

To jump the lid switch you need to unplug the washer and open the console. I have provided you with the instructions for opening the console below. Once you have the console open, locate the connector for the lid switch. Place an insulated jumper between the gray and white wires. Not the green it is a ground and will cause a short. After inserting the jumper make sure it will not touch anything metal, plug the washer in. Then start the washer in a cycle, and let it go. If the washer completes the cycle, you need to replace the lid switch. Do not leave the jumper in while you are waiting for the part. The jumper is only of the test.

To you replace the lid switch you have to remove the cabinet of the washer. The instructions for that are also in the image below. Once the cabinet is removed you can take the screws out securing the lid switch and remove the harness from the clips along the underside of the cabinet. Then reinstall the lid switch in the reverse order. Before you reassemble the cabinet, please read the instructions for installing the cabinet provided in the image.

I hope this is helpful. Please reply below if you need further assistance. Here is a link to order any parts you need. Sears Parts Direct .

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Thank you for using Manage my life. Mark T.

Read More
Mark T -
Sears Technician
January 03, 2011

Recommended maintenance parts & accessories

Show 3 more
No more item to show