Model #11023902200 Kenmore residential washers

  • Top And Cabinet
    3 Results
  • Rear Panel
    3 Results
  • Agitator, Basket And Tub
    3 Results
  • Brake/clutch/gearcase/motor/pump
    3 Results
  • Machine Base
    3 Results
  • Control Panel
    3 Results
  • Wiring Harness
    3 Results
  • Brake And Drive Tube
    3 Results
  • Gearcase
    3 Results
  • Water System
    3 Results
  • Miscellaneous
    3 Results

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

How do I install a lid switch on my Kenmore washer model 11023902200?

A:

You will need to buy the lid switch part number 3949238 and 2 of the replacement screws part number 3356311. To replace the lid switch, unplug the washer and follow these steps:

  • Remove the plastic clip from each side of the console.
  • Remove the hidden screw from each side that you will find after removing the plastic end cap. These screws secure the console to the top panel of the washer.
  • Pull the console slightly forward and then hinge it up and back into the service position as shown in the first image below.
  • Unplug the lid switch wire harness connector.
  • Follow the steps in the second image to release the clips that secure the cabinet to the back washer panel.
  • Pull the cabinet forward as shown to access the lid switch and install the new one.
  • When you snap the cabinet back into place, make sure that the back slots in the bottom rail of the side panels are properly positioned in the metal tabs on the base of the washer.
Reassemble and test the washer. This should fix your lid switch problem.

If you need more help, resubmit your question with additional details.

Read More
Lyle W -
Sears Technician
March 06, 2009
Q:

What is the cu. ft. capacity of the washer model 11023902200 and dryer model 11063012101?

A:

The washer has 3.2 cu. ft. of capacity. The dryer has 5.9 cu. ft.

Read More
Lyle W -
Sears Technician
June 04, 2009