Model #11022954100 Kenmore residential washers

  • Top And Cabinet Parts
    3 Results
  • Control Panel Parts
    3 Results
  • Rear Panel Parts
    3 Results
  • Agitator, Basket And Tub Parts
    3 Results
  • Brake, Clutch, Gearcase, Motor And Pump Parts
    3 Results
  • Machine Base Parts
    3 Results
  • Wiring Harness Parts
    3 Results
  • Brake And Drive Tube Parts
    3 Results
  • Gearcase Parts
    3 Results
  • Water System Parts
    3 Results
  • Miscellaneous And Optional Parts (not Included)
    3 Results

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

washer mod # 11022954100 works properly on heavy cycles on gentle and hand wash fills and clicks doesnt go any further

A:

Your description indicates that you could have wire harness connection problem on that drive motor. The image below shows connection circled in green that would cause the motor to click and not run in the gentle and hand wash cycles after it fills. I recommend that you unplug the washer and check that wire harness connection. You can access that drive motor as shown in this brief repair video: Washing Machine Drive Motor Replacement . You don't have to remove the drive motor, just pull off the cabinet and check that wiring connection. Plug it in securely and then reassemble and test the washer.

This information may help you fix this washer problem. If you need more assistance, reply with additional details.

If you get to a point where you need to have a service technician diagnose and repair this failure, you can schedule one through this link: Sears Home Services .

Read More
Lyle W -
Sears Technician
January 02, 2012
A:

It is safe to use if you insulate the ends of any loose wires so that they don't short out against the metal inside the cabinet. Be sure that you have the washer UNPLUGGED when accessing internal components. You can place a wire nut on the end of any loose wires and position them out of the way with cable ties if necessary. If you are able to replace those wires or reconnect them properly, then the motor may run normally in all cycles. If the motor stops running or you have further problems, then you will probably need to replace the washer. Let us know if you need more help.

Read More
Lyle W -
Sears Technician
January 02, 2012
See more answers