Model #11022802100 Kenmore residential washers

  • Top And Cabinet
    3 Results
  • Control Panel
    3 Results
  • Rear Panel
    3 Results
  • Agitator, Basket And Tub
    3 Results
  • Brake/clutch/gearcase/motor/pump
    3 Results
  • Machine Base
    3 Results
  • Wiring Harness
    3 Results
  • Water System
    3 Results
  • Miscellaneous
    3 Results
  • Brake And Drive Tube 388952
    3 Results

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

How to pop the lid on my washer (Kenmore Model 11022802100) and replace the lid switch (part #3949238)

A:

I see that Joseph has given you a good link to an answered question. I would like to add an image below showing the end caps being removed.

Make sure to unplug the washer before attempting any repairs.

The part number for the lid switch is 3949238. Please click on this link if you need to order the lid switch .

Thank you for using Manage my life.

Here is a link to order any parts you need. Sears Parts Direct .

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Read More
Mark T -
Sears Technician
September 25, 2010
Q:

Washing Machine not working!

A:

Thank you for your question and I understand your concern.

You did not indicate if the washer will operate in the drain and spin cycles or not. If your washer will fill and agitate but not operate at all when the timer advances and reaches the drain and spin cycle then I would assume the lid switch is broken or faulty. If the washer will operate in the drain and spin cycle then I would assume a blockage or restriction in the hose between the tub and the drain pump. Note: Be sure to disconnect the power cord before servicing your washer.

I added a YouTube video showing how to access and replace the lid switch. The part number needed for your washer is 3949238 which can be ordered from Sears PartsDirect

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Read More
Joey S -
Sears Technician
August 08, 2011
Q:

Kenmore 80 series washing machine leaks sporadically...ruled out standpipe drain

A:

Hi Dan,

Thank you for submitting a question to Manage My Life.

Intermittent issues are the hardest to diagnose. If your washer worked for over 2 years at that drain pipe height I do not think that is the issue now. Here is what I recommend, take the cabinet off the washer and look for signs of a leak. There should be water stains on one of the water containing components. Here is a video that demonstrates the disassembly of a washer similar to yours; Video . Always unplug or de-energize electrical equipment before removing covers or attempting service. Be careful and wear appropriate hand protection when working around sharp metal parts. The washer in this video may not look exactly like yours, but the procedure is basically the same. Be sure to look around the hoses, tub, pump, and fill valves.

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Here is a link that you may use to view the parts list diagram or to purchase any parts needed; Sears Parts Direct .

I hope this is helpful. Check the things I have covered here, and if I may be of further assistance, include more details in a reply to this post.

Landell

Read More
Landell -
Sears Technician
January 11, 2012

Recommended maintenance parts & accessories

Show 3 more
No more item to show