Model #11021086000 Kenmore Elite residential washers

  • Top And Lid
    3 Results
  • Cabinet And Frame
    3 Results
  • Washplate, Basket, And Tube
    3 Results
  • Control Panel
    3 Results
  • Brake/motor/pump
    3 Results
  • Suspension
    3 Results
  • Brake And Drive Tube
    3 Results
  • Miscellaneous
    3 Results

Question and Answers

Q:

Can you help me find a part for my model 11021086000 washer?

A:

The part you need is attached to the wash basket and is not replaceable. I assume you got the part number off the part itself. All parts are assigned a part number for the manufacturing process, but all part are not replaceable separately. To replace this part you will have to replace the wash basket.

I'm sorry you have gone to all this trouble to find out you have to buy an expensive wash basket to replace the cracked part. The part number for the wash basket is 285913 and the cost is around $180.00. You might find a used washer with a good wash basket and repair it cheaper. Good luck.

Read More
Jimmy K -
Sears Technician
May 12, 2008
Q:

Where does the seal go when replacing washplate?

A:

I assume you are talking about the drive hub o-ring. I have included a set of illustrations that show u-joint and the area below the agitator.

If you need more assistance please resubmit question with more details. I will be looking forward to helping you again in the near future.

Note: Our imaging system is malfunctioning. I would like to apologize in advance if the attachments do not appear online.

Read More
Landell -
Sears Technician
December 22, 2009
Q:

my calypso #11021086000 gives the Ld error code at different times during a cycle. is there anything I can do to re-program the machine to finish a load?

A:

The Ld error code does indicate that you have a "long drain" situation in the washer. This is normally caused by problem with the drain system in the washer. It can also be caused by excessive suds. Make sure that you are using the correct amount of HE (High Efficiency) detergent to avoid excessive suds.

If you detect no excessive suds, I recommend that you check the washer drain to make sure that it is working properly. Check the drain hose for kinks or clogs. For more advanced troubleshooting, you will need to unplug the washer and access the drain pump as shown in the image below. You can check the drain pump and connecting hoses for clogs. You may need to replace the drain pump if it is damaged. A problem with a clog in the check ball assembly can also prevent the washer from draining.

These tips may help you resolve this issue with your washer. If you need more help, reply with additional details.

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Read More
Lyle W -
Sears Technician
September 27, 2010