Model #10T802-0708-EA Briggs & Stratton engine

  • Cylinder/crankshaft/crankcase
    3 Results
  • Rewind Starter/blower Housing
    3 Results

Question and Answers

Q:

Mounting a 842242560 snowblower to craftsman yard tractor.

A:

Thank you for your question.

 

I will be happy to assist you. I tried to look up the model number you submitted. I could not get that model number to come up. I think it may be one number off. I should be able to assist you without the model number. If the model number does start with 842 it will not fit the tractor. The reason is the tractor frames were changed in 2006. Anything snow blower before then will not fit. The manufacturer of the snow blower went out of business some time ago and most of the parts are no longer available. I checked the part numbers and most are no longer available.

 

 

I hope this is helpful. Please let me know if you need further assistance.

 

 

Thank you for using Manage my life.

 

Mark T.

Read More
Mark T -
Sears Technician
October 03, 2013
Q:

What does the fault code F7 EA indicate on my GE electric slide-in range?

A:

The F7 EA error code indicates that the electronic control board detects a stuck button on the key pad. This is normally caused by a failed control console. It can sometimes be caused by a bad electronic oven control board. A technician will shut off the breaker to disconnect electrical power to the oven and conduct an ohm test as described in the image below. If any of the keys on the control panel are not operating properly, then the control panel will need to be replaced.

You can order parts for this oven through the Sears PartsDirect website. The part number for the control panel is WB36T10609 according to the model number that you submitted (JKS06BF4BB).

If you are not able to perform the ohm test on the control panel, you can likely fix this problem by replacing the control panel. If you still have the error code after replacing the control panel, then you would need to replace the control board (part WB27T10413).

Read More
Lyle W -
Sears Technician
March 09, 2009
Q:

Installing Sears crankshaft in Briggs model 10T802. Need a number for the rod bearing torque and can't find it. Can you tell me? From Sears mower. Bob

A:

I have provided you with an image below out of the service manual. The connecting rod bolts should be torque to 100-inch pounds. Your model is a 100000. If you need further assistance, please feel free to submit more details.

Thank you for using Manage my life.

Here is a link to order any parts you need. Sears Parts Direct .

Read More
Mark T -
Sears Technician
August 22, 2010