Model #10672294201 Kenmore top-mount refrigerator

  • Cabinet
    3 Results
  • Liner
    3 Results
  • Shelf
    3 Results
  • Refrigerator Door
    3 Results
  • Unit
    3 Results
  • Icemaker
    3 Results
  • Freezer Door
    3 Results

Troubleshooting

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

How do I put my old Acceler Ice on a new ice maker, 4317943, for Kenmore Elite Mod 10672294201?

A:

The Acceler Ice is a separate part from the icemaker and when the icemaker is replaced the old acceler ice should be moved to the replacement icemaker. There are no instructions doing this because this job is usually done by a technician who would have received training on moving the acceler ice over to the new icemaker. If you look at the parts diagram the acceler ice is listed as item 18.

It is fairly easy to change the acceler ice over to your new icemaker. Release the 2 clips holding the acceler ice to the icemaker. There is one at the front right lower corner and one at the top left upper corner. Pull the acceler ice away from the old icemaker. You need to remove these clips and install them on the new icemaker.

Remove the plastic cover on the motor of the new icemaker. It pries off with a small flat blade screwdriver.

On the back of the acceler ice there are 2 prongs sticking out. These prongs plug into the holes on the front of the icemaker labeled T and H. If you line the corners of the acceler ice up with the corners of the new icemaker, the prongs will line up with the T and H openings.

I hope this helps you. If you have any questions, send another email.

Read More
Jimmy K -
Sears Technician
September 23, 2008