Model #10670282990 Kenmore top-mount refrigerator

  • Cabinet
    3 Results
  • Liner
    3 Results
  • Shelf
    3 Results
  • Refrigerator Door
    3 Results
  • Unit
    3 Results
  • Icemaker
    3 Results
  • Freezer Door
    3 Results

Troubleshooting

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

ice maker 10670282990 Kenmore Top mount refrigerator

A:

That leak is normally caused by a failed inlet water valve (part 2315576). 

 

To verify that failure, you can try this test:

 

 

  1. Unplug the refrigerator.
  2. Access the wire harness disconnect plug for the ice maker. Unplug the wire harness.
  3. Tape the ends of the wire harness plugs with electrical tape.
  4. Mount the ice maker back on the wall of the freezer if you had to pull it down to disconnect the wire harness.
  5. Monitor the ice maker and see if the water continues to leak into the ice mold. The ice maker will not cycle when the harness is disconnected.

 

This test will determine whether the inlet water valve is getting voltage from the ice maker assembly due to a stuck contact. This would cause that leak.

 

If the leak stops when the wire harness for the ice maker assembly is unplugged, then you will need to replace the ice maker assembly.

 

If the water continues to leak with that wire harness unplugged, then you will need to replace the inlet water valve.

 

Unplug the refrigerator and shut off the water supply before accessing and replacing internal components. The water valve is at the bottom of the refrigerator in the machine compartment. Remove the bottom back panel on the refrigerator to access that inlet water valve.

 

If you need more help, reply with additional details and we will assist you further. 

Read More
Lyle W -
Sears Technician
November 05, 2013