Model #10659592990 KENMORE side-by-side refrigerator

  • Cabinet
    3 Results
  • Refrigerator Liner
    3 Results
  • Refrigerator Shelf
    3 Results
  • Freezer Liner
    3 Results
  • Motor And Ice Container
    3 Results
  • Refrigerator Door
    3 Results
  • Freezer Door
    3 Results
  • Dispenser Front
    3 Results
  • Air Flow
    3 Results
  • Controls
    3 Results
  • Unit
    3 Results
  • Icemaker
    3 Results

Troubleshooting

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

The shelf stud from Kenmore model 10659592990 broke off. The replacement part screws in, the original was fixed in the wall.

A:

The part numbers I see for the studs that hold the slide out crisper cover are 2196483 for all except the left front. The part number for the left front stud is 2196485. Each of these studs comes with a screw which is part number 8181158 for all except the left front. The part number for the left front screw is 3400894.

It looks like the screw would go into the refrigerator wall and the stud would attach to the screw. If you need further help send another question and try to give us a complete explanation of why it doesn’t work.

Read More
Jimmy K -
Sears Technician
April 16, 2008
Q:

Refrigerator is leaking water from the door water dispenser.

A:

There is a switch in the dispenser that energizes the solenoid water valve that is located just inside the machine compartment in the back bottom portion of the refrigerator. When the solenoid water valve is energized, it opens to allow water pressure to push water through the filter and then up through the fitting that is leaking using the water pressure applied through the water line connection on the back of the refrigerator. If the solenoid water valve is leaking, it could cause the drip that you are describing. The ice maker uses the same type of valve (located on the same assembly just beside the water dispenser valve). If the ice maker is working and filling properly then there is a chance that you will need to replace the water valve assembly (part 4389177) if the drip is constant. You can order the valve assembly from the Sears PartsDirect website. The procedure for replacing that component is shown in the image below. NOTE: Be sure that you unplug the refrigerator before accessing internal components.

Before you replace the water valve, I recommend that you check for another issue that could be causing this problem. If you recently replaced the water filter but did not purge a few gallons of water through the dispenser as shown on page 12 of your owner's manual, air trapped in the line could cause the dispenser to drip. Here is a link for your owner's manual in case you need it: Owner's Manual . An interruption in water service could also cause air to be trapped in the water lines inside the refrigerator. Try purging water from the dispenser and see if that corrects your problem.

If the dispenser still drips constantly after trying this troubleshooting then you will likely need to replace the water valve assembly.

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Read More
Lyle W -
Sears Technician
July 02, 2010

Top Parts