Model #10653662300 KENMORE side-by-side refrigerator

  • Cabinet Parts
    3 Results
  • Refrigerator Liner Parts
    3 Results
  • Refrigerator Shelf Parts
    3 Results
  • Freezer Liner Parts
    3 Results
  • Motor And Ice Container Parts
    3 Results
  • Refrigerator Door Parts
    3 Results
  • Freezer Door Parts
    3 Results
  • Dispenser Front Parts
    3 Results
  • Air Flow Parts
    3 Results
  • Control Parts
    3 Results
  • Unit Parts
    3 Results
  • Icemaker Parts, Parts Not Illustrated
    3 Results

Troubleshooting

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

How do you remove the drip pan from Kenmore refrigerator model 10653662300?

A:

I assume that you are referring to the drip pan underneath the refrigerator (Key 25 in the image below). I do not believe that this part can be easily removed through the front of the refrigerator. You may be able to gain limited access to it from the front of the refrigerator after removing the front toe grille. You should be able to gain better access to it by unplugging the refrigerator and removing the bottom service panel on the back of the refrigerator. With this panel removed, you may be able to pull the drip pan out. If not, you can likely reach the drip pan with an attachment on a wet/dry shop vacuum. You can also us liquid chlorine bleach to help clean the drip pan and prevent mildew.

NOTE: If you remove the back service panel, be sure that it is properly replaced before returning the refrigerator to normal use. The refrigerator will not operate properly with this panel removed.

Read More
Lyle W -
Sears Technician
September 17, 2008
Q:

Kenmore side by side refrigerator #10653662300: The unit has a defrost cycle malfuntion. I have a volt/ohm meter. Thank you for a list of parts to examine

A:

I provided technical information for this refrigerator in the images below. You can place the refrigerator in a forced defrost mode by following the procedure shown in that first image. This will help you determine whether the defrost heater is working. If not, you could have a problem with the defrost termination bi-metal thermostat. Here is a link for a video that shows the components in the automatic defrost system of a refrigerator: Video: Refrigerator Not Cooling Repair . If the defrost heater does not heat, I recommend that you check the continuity through that bi-metal thermostat first. If that component is okay, you can check the resistance of the defrost heater. That heater should measure around 20 to 30 ohms of resistance. If both of those components are okay, you could have a wiring failure or a bad electronic control board. You can view and order parts on the Sears PartsDirect website. Be sure that you unplug the refrigerator before accessing internal components.

If you need more help, reply with additional details and we will assist you further.

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Read More
Lyle W -
Sears Technician
July 20, 2011

Top Parts