Model #1030 Dirt Devil vacuum, upright

  • Metal Uprights
    3 Results
  • Wiring Schematic
    3 Results

Question and Answers

Q:

Pro-form 760 Treadmill, new maintenance free belt, motor stops after 10-30 minutes of use

A:

Based on your description, it is likely that a mechanical friction problem is causing the motor to overheat. The links for previous answers provided by Jacqueline S. in the above response provide some troubleshooting help for friction problems. I recommend that you make sure that your belt tension is adjusted properly. Page 24 of your owner's manual shows this procedure. Here is a link for the owner's manual in case you need it: Owner's Manual .

You indicated that you replaced the belt with a new maintenance free belt. The part number for the replacement belt on this treadmill is 173063. If that is the belt that you used, then you should be able to adjust it properly. In some situations, you may still need to add some lubricant to the walking board of this treadmill even though the walking belt is called "maintenance free". If you adjust the belt and detect no mechanical friction problems as described in the links above, then you can use a kit that will safely lubricate the board and belt 173063. The part number for the lubricant kit is 219168. Here is a Sears PartsDirect.com link for that kit: Lube Kit .

These tips may help you resolve this treadmill problem. If you need more help, reply with additional details and we will try to assist you further.

Read More
Lyle W -
Sears Technician
November 13, 2010
Q:

Why does my Proform 770EKG treadmill stop running after a few seconds?

A:

Without a model number I am able only to give generic repair advice. Several things can cause the belt to slow down when you walk on it. The motor controller or the motor can cause this problem. To test the motor and controller someone needs to read the motor output at A+ and A- on the motor controller with the treadmill running. This will be between 10-80 VDC. Then let someone step on the belt and walk and see if the voltage increases to compensate for the load. Usually the voltage will increase 5-10 VDC. If the voltage increases the controller is doing its job and the motor is weak.

The most common cause of the belt slowing down is a dry or worn out belt and or board. Lift the edges of the belt and look at the walking board and feel of the belt and board. They should be smooth and slick. If the walking belt and board do not seem worn, you should lubricate the belt and board.

If you require further assistance please resubmit question with the complete model number and more details. I will be looking forward to helping you again in the near future.

Read More
Landell -
Sears Technician
January 04, 2010
Q:

Flame too low on Kenmore propane gas grill, model number141.163231

A:

Thank you for your question.

I can understand wanting to have full flame for cooking on the BBQ.

My first suggestion is to turn the LP tank valve off and then unhook the hose from the tank and open all the burner valves.

Wait about 15 minutes and close all the burner valves and then reconnect the hose to the tank.

Turn the LP tank valve on very slowly. Only turn the valve about a 1/4 of a turn. Then light the farthest burner from the LP tank first and then light back the burners one at a time.

If that does not solve the problem then I would suggest replacing the regulator part number: P03601002A for about $30.00.

Please reply with how that works and if you need more help, I will be glad to help you further.

Thank you for using Manage My Life.

Read More
Sam A -
Sears Technician
July 18, 2011