Model #09P702-0007-F1 Briggs & Stratton engine

  • Cylinder/crankshaft/sump
    3 Results
  • Head-cylinder
    3 Results
  • Carburetor/gasket Sets
    3 Results
  • Fuel Tank/muffler
    3 Results
  • Blower Housing/flywheel
    3 Results

Question and Answers

Q:

craftsman model 917.272751 valve adjustment

A:

Thank you for your question. I usually set both of the valves at .005� and never had a problem. I have looked up your model and it is a 310000 series engine. The image below has all of the specifications for your engine. The intake is .003� to .005� and the exhaust is .005� to .007�. Make sure to adjust the valves when the engine is cold. A warm engine will throw the settings off. If you have any other questions, please feel free to reply below.

Thank you for using Manage my life. Mark T.

Read More
Mark T -
Sears Technician
October 03, 2010
Q:

What does it mean when the F1 alarm goes off?

A:

I am sending you an image from the tech sheet for your range. The F1 code usually indicates the electronic oven control is bad.

Read More
Jimmy K -
Sears Technician
May 07, 2008
Q:

What does the code F1 mean?

A:

The "F1" fault code is indicating one of the three failures listed below:

  1. Shorted keypad
  2. Electronic Oven Control's internal checksum may have become corrupted
  3. Electronic Oven Control has sensed a potential runaway oven condition. Control may have a shorted relay, oven sensor probe may have gone bad.

If the oven has runaway temperature, leave the breakers turned off.

The first component to test is the oven temperature sensor probe. I added an image with the specific resistance value of the oven sensor probe. You will need to compare the resistance readings of your oven sensor probe to the chart.

The oven temperature sensor probe is located inside the oven cavity and can be found protruding into the oven cavity from the rear panel. It can be removed and disconnected by removing the two screws. If the oven sensor has the correct resistance readings according to the chart I added, then the most likely the Oven Control Board has failed and will need to be replaced. The Electronic Oven Control (EOC) will cost approximately $150.00

Disconnect power, wait 30 seconds and reapply power. If the fault returns upon power-up, replace the Electronic Oven Control (EOC).

I recommend calling a service technician to diagnose and repair your range.

Read More
Joey S -
Sears Technician