Model #020241 Troybilt power washer, gas

  • Main Unit
    3 Results
  • Pump Assembly
    3 Results
  • Main Unit
    3 Results
  • Pump
    3 Results
  • Main Unit
    3 Results
  • Pump
    3 Results
  • Main Unit
    3 Results
  • Pump
    3 Results

Question and Answers

Q:

Breather tube - pressure washer 020241

A:

Thank you for your question.

 

I am sorry you are having a problem with the pressure washer. Usually when this happens it is because the engine is over full of oil. If you have adjusted the oil level, I recommend wiping the engine down and remove the air filter. Then start the engine and pull the trigger on the wand so the pump does not over heat. After about five minutes, the oil should stop coming out of the breather. If it does, turn the engine off and check the air filter. If the filter is oil soaked, it should be replaced. If the filter is fine, go ahead and reinstall it. The pressure washer can be used normally.

 

If the oil does not stop dripping ,the problem is likely a defective crankcase breather. The breather should allow the engine to breathe without leaking oil. To correct the problem I recommend replacing the breather. You can order the parts from the following link. Replacement pressure washer parts. 

I hope this is helpful. Please let me know if you need further assistance.  

 

Thank you for using Manage my life.

 

Mark

Read More
Mark T -
Sears Technician
September 04, 2013
Q:

I just purchased part #190673GS (manifold) and want to know how to install on my Troybuilt 020241 pressure washer

A:

We don't have instructions or images for replacing the manifold on your pump.

You can disconnect the inlet and outlet hoses and remove the bolts that hold the manifold to the pump and remove the manifold.

You will need to remove the unloader valve, detergent dispensing valve, and any other plugs or valves that are in the old manifold. These parts will need to be installed inside the new manifold.

You can make the nuts and fittings easier to remove by placing the old manifold on a hard surface such as an anvil, vise, or concrete walk or driveway. Hit the manifold with a hammer (not hard enough to warp or bend the manifold) several times on each side of the fitting. The vibration will make the fittings easier to remove.

You might damage some parts such as the unloader valve when removing and installing them. If you are not comfortable replacing the manifold, you can take the new manifold and pressure washer to a Sears Parts and Service Center or a Sears Retail Store for repair.

Read More
Jimmy K -
Sears Technician
May 28, 2010
Q:

Honda engine for troy bilt pressure washer

A:

Thank you for your question.

 

 

I am sorry you are having a problem with the pressure washer. I searched all our Honda documents for issues with the Honda GC160 but I do not have any. If the engine was sitting for years, the oil might have been contaminated with moisture. It is hard to say without taking the unit apart. To ensure you get the correct replacement engine I will need the model number off the engine. On the right side of the engine, you should see a model number tag. If you could reply below with the full model number and serial number, I will be sure to provide you with the correct number.

I hope to hear from you.  

 

 

 

 

Thank you for using Manage my life.

 

Mark T.

Read More
Mark T -
Sears Technician
October 09, 2013

Recommended maintenance parts & accessories

Show 3 more
No more item to show