Kenmore Elite Dryermodel #11067042600
Questions & Answers about this model powered by
We have a team of experts and an active community here to answer any questions you have. In addition to help from the community, our experts actively follow up on questions to get you the information you need.
My Kenmore Elite Turbo Super Capacity Electric Dryer Model # 110.67042600 will not work. Power will turn on, but it will not start.
Posted April 10, 2013
Dezeray, April 10, 2013
Washers are appliances we use daily do so when it stops working it can be really frustrating. While you are waiting on an expert to answer your question, I suggest you set service with a Sears technician. I have attached the link below. Hope this helps!
Lyle W , April 12, 2013
I am sorry to hear about this problem that you are having with your Kenmore Elite Dryer Model 110.67042600.
You could have a problem with the door switch, the thermal fuse, the drive motor, the electronic control board or the wiring that would prevent the dryer from running.
You can check the door switch using the diagnostic test that I posted in the first image below. If that door switch is bad, then it will need to be replaced. You can order parts from this page: Kenmore Elite Dryer Model 110.67042600 Repair Parts. Unplug the dryer before accessing internal components and replacing parts. The second image below shows how to access and replace the door switch in this dryer.
If the door switch is okay, then you could have a blown thermal fuse. That fuse is located on the housing of the fan. Reply with additional details if you need help accessing and checking that fuse.
If you get to the point where you need to have a service technician diagnose and repair this failure, you can schedule service through this link: Sears Home Services Dryer Repair.
Kelli, April 12, 2013
After doing the test, the dryer is flashing F 28 and when I open the door, it is flashing 2E. Not sure what either of these mean. I appreciate your help in this! I am happy to check the fuse too, if needed.
Lyle W , April 12, 2013
Your details seem to indicate that the door switch is okay since the display changes when the door is opened and closed. The F28 code indicates that you have a problem with the moisture sensor circuit. I posted information about that component failure in the first image below. You can access that moisture sensor by removing the front panel (with the dryer UNPLUGGED). The second image shows how to access the thermal fuse. It is tight in that cabinet with the front bulkhead still attached to the front of the dryer. If you can remove that thermal fuse, you can check it for continuity using a volt/ohm meter. You should measure near zero ohms of resistance through that fuse. If the fuse is "open" (measure OL -- open load or infinite resistance) then it is blown and will need to be replaced. Note: Check your exhaust vent duct system to the outside of your home for a clog or restriction if that thermal fuse was blown. If the thermal fuse is okay, then you could also have a broken drive belt that would prevent the motor from running. You can check that issue with the front panel removed. If you need more help, let us know.
Have a repair or installation question about this model?