• Recently Viewed  
  • Cart 

    Your Shopping Cart

    Showing last added item

    Parts Qty

    Total items:

Can't locate your model number? Use our finder

Choose your product type

Common model number plates

View sample model numbers by selecting your product brand


Craftsman garage door openermodel #13953650SRT

Add this model to "My Models" for easy access later.

Craftsman Craftsman garage door opener Model #13953650SRT was saved to your profile.

You have reached the maximum number of models that can be added to your list.

Please Sign In or Register to have unlimited usage.

Questions & Answers about this model powered by

Garage door opener has learning LED light flashing

Garage door opener 13953650SRT, Green LED next to green learning button flashes 5 times. What does this indicate?

Posted March 24, 2013


Barbara, March 24, 2013

flashing led lights in a garage door opener is usually a dianotic code. these ar often listed in the owner's manual. i attached the one for this model below if you wouild like to check while waiting for the expert.

AnneJ, March 26, 2013

i know that it can be very difficult to have issues with your garage door opener.  on this model there are two possibilities for your garage door opener green lights flashing. either the rpm sensor is defective or the motor is overheated. below i have included an image on the information for this code. also check the following. first verify that the trolley is against the stop bolt. release the door from the opener by pulling the emergency release rope. manually bring the door to a closed position. loosen the belt by adjusting the outer nut 4 to 5 turns. this relieves the tension. run the motor unit from the remote control or door control. the trolley should travel towards the door and stop. if the trolley re-engages with the door, pull the emergency release rope to disengage. re-tighten the outer nut until the trolley spring is approximately 1-1/4" (3.18 cm) in length. if the trolley does not move away from the bolt, repeat the steps above. also make sure the safety sensors are correctly installed and aligned. i hope this helps. if you need further assistance, please reply to this thread. thank you for using manage my life.


M-F 6:30 a.m. - 10:00 p.m. CST
Sat 7:00 a.m. - 9:00 p.m. CST
Sun 7:30 a.m. - 9:00 p.m. CST

Thank you! Your model has been added.

Save model in your profile permanently

Don't have a profile? It's fast and easy to create one. Sign up now and you can access your models anytime, anywhere.

Sign In Register

Save to this computer*

This option is valuable if you expect to revisit Sears PartsDirect using this computer and browser in the future.

*Saved models will only persist on this computer and browser. Model retention may be affected by your browser settings.

OK, Continue