Model #YKERS807SP00 KITCHENAID Free Standing, Electric

  • Cooktop Parts
    3 Results
  • Control Panel Parts
    3 Results
  • Oven Parts
    3 Results
  • Door And Drawer Parts
    3 Results
  • Internal Oven Parts
    3 Results
  • Top Venting Parts, Optional Parts
    3 Results
Find part by diagram >

Question and Answers

Q:

KitchenAid YKERS807SP00 - display does not work

A:

I am sorry that you are having some difficulties with your range and I will be happy to help. I did some research and I was able to find two links that will provide you with some good information. I hope this helps while you wait for your expert response.

Read More
Joseph P. -
May 08, 2012
A:

Hi, Do you have any information on that particular model? Maybe a wiring diagram? Thank you, Denis

Read More
Denis -
May 09, 2012
A:

The first image below shows the entire wiring diagram for your range. The second image shows the connections for the transformer and the user interface control board. I traced some of the essential wiring connections in green and blue (not the actual wire colors). You could have a blown thermal cut-off fuse or a bad transformer. A loose wiring connection or a bad user interface control board would also cause this problem. That information may be what you need to diagnose and repair that failure. Be sure that you unplug the range before accessing internal components. You can view parts on this page: KitchenAid Range YKERS807SP00 Parts .

If you need more help, reply with additional details and we will assist you further.

Read More
Lyle W -
Sears Technician
May 10, 2012
A:

Hi Lyle, Thank you very much for your help! I really appreciate it. I will check all the connections and will let you know how everything is. Thanks!!! Denis

Read More
Denis -
May 12, 2012
A:

Hi Lyle, I have checked voltage in block P1 (ACV from 17 to 28 volt, DCV 7 volt,) and I checked P2 (DCV � 5.3 volt), it seems like thermal cutoff and transformer are ok. How can I check if the Switch and Electrical Control work?

Read More
Denis -
May 13, 2012
A:

Denis,

Lyle is taking some vacation time. I will be answering his questions for a few days.

If you have voltage to the user interface out of the transformer and the user interface will not light up, you need to replace the user interface (part number W10181439). Those specific voltages are: pins 1 to 2 = 3.5VAC (yellow wires), pins 2 to 3 = 3.5VAC (yellow wires), pins 4 to 5 = 12VAC (blue wires), and pins 6 to 7 = 26 to 42VAC (red wires).

I hope this is helpful. Check the things I have covered here and if I may be of further assistance please reply to this post.

Landell

Read More
Landell -
Sears Technician
May 14, 2012
See more answers

Top Parts