Model #X83 KENWOOD Misc Audio

  • No Image Available - Fidelitone
    3 Results
Find part by diagram >

Question and Answers

Q:

need to tighten tension belt on dryer DDE7500GALAD

A:

Thank You for contacting SearsPartsDirect.com
I do apologize for the delay in answering your question.

Based on the model you have provided. I'm showing your not able to tighten the belt. You will need to replace the belt, idler pulley, and idler spring. I have provided the part numbers below for each part.

Belt part # WE12X42

Idler Pulley # WE12X83

Idler Spring # WE3X69

If you need further assistance, please let me know. Thanks for visiting SearsPartsDirect.com

Read More
Desirea -
Sears Technician
December 01, 2013
Q:

Conversion kit for gas cooktop

A:

Wanting to order a kit to convert your range is very important to know which kit to get. While you are waiting on an expert to answer your question, I suggest you visit Sears Parts Direct website to speak with a sears associate to find out what kit is best. I have attached the link below.Hope this helps!

Read More
Dezeray -
October 10, 2012
A:

There is not a kit available for converting that cooktop from LP to natural gas. The orifices are available from Sears PartsDirect if they were not retained when the cooktop was converted to LP gas. The part number for the large natural gas orifice (10,000 BTU) is WB6X94. The part number for the small natural gas orifice (6,000 BTU) is WB6X83. This cooktop appears to have two large burners and 3 small ones. You will need to order 2 of the large orifices and 3 of the small ones to complete that conversion.

NOTE: A qualified installer should complete that natural gas conversion. The orifices will need to be replaced. A 7mm nut driver should fit the orifices. The installer will need to convert the pressure regulator back to natural gas as shown in the image below.

You can contact your local gas supplier for an installer. You may also be able to find a pre-screened service provider on the ServiceLive.com website.

If you need more help, let us know.

Read More
Lyle W -
Sears Technician
October 11, 2012
See more answers
Q:

A Sears technician repaired my dryer in May. Two days ago, a stringy piece of plastic/rubber was in dryer. It still works. Should I call and make an appointment?

A:

Hello, It is great that your appliance is still working properly. However, you should only schedule a maintenance or service appointment if your appliance is working improperly. There is no need to spend money for a tech if you don't have to. I hope you appliance continues to work properly!

Read More
Jacqueline S -
July 08, 2010
A:

From your description, it sounds like pieces of the inner door gasket have fallen off. The dryer will work perfectly fine however, over time the gasket may fall apart. The gasket seals the dyer shut and without it, hot air will leak. This was not apart of the initial service call based off the parts list. You can reschedule a service but you may have to pay additional charges. You can visit www.SearsHomeServices.com and click on "repair" to begin.

Read More
Rgabriella02 -
Sears Technician
July 09, 2010
See more answers