Model #WW30430B JENN-AIR Built-In Oven, Electric

  • Control Panel
    3 Results
  • Body
    3 Results
  • Oven
    3 Results
  • Internal Controls
    3 Results
  • Door
    3 Results
  • Wiring Information
    3 Results
Find part by diagram >

Question and Answers

Q:

I have Model #WW30430B Jenn-air Electric wall oven which gives me F2 error. What does it mean and how to fix the problem? WW30430B Jenn-air Electric wall oven

A:

Thanks for the inquiry and for using SearsPartsDirect.com.

I am sorry to hear of the issue with the element staying on in the oven, as well as the error received. I know how frustrating that is to have occur.

The F2 error code indicates an issue with the oven temperature circuit. This would include the oven temp sensor and the electronic control board. I would suspect that with the element staying on, it would be an issue with the electronic control's relay that supplies power to the element. 

In this situation, we would recommend having a technician assist with the troubleshooting and repair. If you would feel more confident have a Sears Home Service technician help assist with the diagnosis/repair, you can call 1-800-349-5071, or click here to be directed to the page to set up service.

Let us know if we can be of any further assistance and thanks for using SearsPartsDirect.com.  

Read More
Jeff Wallace Sr -
Sears Technician
November 27, 2013
Q:

I have a jen - air wall oven ww30430b every time i go to use the top oven I get an f5 error code but the bottom oven still works WW30430B Jenn-air Electric wall oven

A:

Thank you for choosing Sears Parts Direct. I can certainly understand how frustrating it can be when your Wall oven displays an error code.  I did look into the model number you have provided and I have found that the F5 error code means there is a problem with the oven temperature sensor.

The oven sensor should be removed and tested with an ohm meter for proper resistance first. At 100 degrees the oven temperature sensor should have a resistance measurement of 1143 ohms if it's okay. If the oven sensor measures with the correct amount of resistance according to the oven resistance table then the connections will need to be checked on the power relay board.

I recommend calling a service technician to diagnose and repair your wall oven.

Thanky ou for your question. Have a great day.

Read More
Natasha12 -
Sears Technician
November 06, 2013
Q:

I have jennair doube wall oven ww30430B and getting error code "f4" when try to turn on lower oven

A:

When you get an error code, like F4, on the Jennair wall oven, it is described in the link provided below. An expert will respond to your specific model within two business days, usually sooner. If you decide on service, that link is also available.

Read More
Anna T -
February 04, 2013
A:

Thank you for your question and I understand your concern.

The "F4" fault code implies a shorted temperature sensor probe inside the lower oven cavity or it could have a shorted temperature sensor circuit.

The oven sensor probe will need to be taken out from inside the lower oven and tested for proper resistance with an Ohm meter. It should measure approximately 1000 Ohms at room temperature. At 100 degrees is should measure approximately 1143 Ohms. If it measures shorted/continuity, replacing the sensor will resolve the fault code. If it does not, the sensor circuit will need to be checked to see if the wires are shorted to ground or each other. If the sensor and wires are not shorted, then I would suspect a faulty electronic oven control.

To remove the oven temperature sensor:

  1. Remove the two 1/4 inch hex screws, pull the sensor into the oven cavity to gain access to the quick disconnect connector.
  2. Reverse the procedure to re-install the new sensor.

The oven temperature sensor #12001656 can be ordered from Sears Parts Direct.

I hope this is helpful. If I may be of further assistance as more details become available, please reply to this post. If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Read More
Joey S -
Sears Technician
February 05, 2013
See more answers