Model #WTW5500SQ2 WHIRLPOOL Residential Washers

  • Top And Cabinet Parts
    3 Results
  • Controls And Rear Panel Parts
    3 Results
  • Agitator, Basket And Tub Parts
    3 Results
  • Brake, Clutch, Gearcase, Motor And Pump Parts
    3 Results
  • Machine Base Parts
    3 Results
  • Wiring Harness Parts
    3 Results
  • Brake And Drive Tube Parts
    3 Results
  • Gearcase Parts, Optional Parts (not Included)
    3 Results
Find part by diagram >

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

Washer moving around floor in spin cycle WTW5500SQ2 Whirlpool Residential washer

A:

Thank You for choosing Sears PartsDirect.com and being a valued member. It is unfortunate to hear that you are having issues with your washer and I do understand your frustration. Glad to help out. I'm looking at your model number wtw5500sq2 and from your description I would also suspect an issue with the suspension system in the washer. The suspension is made up of several springs and I recommend removing the cabinet and try to determine if the springs are stretched out or if something else is causing the movement. Here is a link that may help with additional troubleshooting. Just click the blue link above to be taken to the page. I trust this information will help you.

 

Thank you for choosing Sears PartsDirect.com.

 

SAFETY NOTICE: Be sure to disconnect power to the appliance before performing any repairs. If you are not comfortable with doing any voltage checks that might be recommended, please contact Sears for repairs. Be aware that there could be sharp edges inside the appliance that could cause cuts or other injuries to yourself or others.

Read More
Sherman_G_Wallace -
Sears Technician
December 18, 2014
Q:

washer does not fill-up! Hot and cold water attached and does run!

A:

I understand how important it is for your washer to be working so that you can do your laundry without any further delay and although your washer is not working properly, I will be happy to help. While you are waiting for an expert answer, I did mange to find a link that will provide you with more information about your problem.

Read More
Priscilla V -
October 04, 2011
A:

Thanks for the interesting question.

The cold fill is theory would be approximately 70 degrees. If you are located where the cold water is much colder then you might see hot water dispensed.

The final temperature of the tub should be approximately 70 degrees.

The straight cold then straight hot doesn't sound right. I suspect you have a problem with the ATC control board.

If the washer won't fill the next load I suspect the water level switch or hose has a problem. Check that the hose from the water level switch is not kinked or twisted. With the tub empty you can remove the hose and blow through it towards the tub to clear any obstructions.

If "water comes but tub does not fill" then check the drain hose has an air gap and is not stuck to far down the standpipe. This might cause a siphon problem where the water would fill and empty at the same time.

I hope this information is helpful to you and thanks for taking the time to submit a question.

Read More
Fred M -
Sears Technician
October 05, 2011
See more answers

Top Parts