Model #WSM2700WAWWW GE Laundry Centers/Combos

  • Control Panel
    3 Results
  • Dryer Upper Cabinet, Drum & Heater
    3 Results
  • Dryer Motor, Blower & Belt
    3 Results
  • Washer Lower Cabinet & Top
    3 Results
  • Washer Motor & Tub
    3 Results
  • Transmission
    3 Results
Find part by diagram >

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

washer motor replacement

A:

I know how helpful it is to have step by step instructions to properly install the motor for your washer. I researched your question and was unable to find information that would be helpful. An expert will respond shortly. It usually takes 24-48 hours to receive a response. Have a good day.

Read More
Jackie S -
July 15, 2012
A:

When it comes to replacing parts on the washer can be difficult. I have done some research on the Manage My Life website and have located a link similar to your issue. While you are waiting for a detailed reply from an expert I have provided the link below. Hope this helps!

Read More
Priscilla V -
July 15, 2012
A:

Thank you for your question and I understand your concern.

I added an image below with the procedure. NOTE: Disconnect the power cord from the power source before removing the front panel.

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Read More
Joey S -
Sears Technician
July 17, 2012
A:

Hello, I also have a General Electric Washer Dryer Combo WSM2700HCWWW. Recently when switched off, there is a slow and steady water drip into the washer tub. I think the water inlet valve needs to be replaced. Found the part: http://www.searspartsdirect.com/ge-washer-dryer-combo-parts/WH13X10002/0026/363/model-WSM2700WAWWW/0432/0152000.html But how do you access the water inlet valve? I found the exploded parts diagram but removing and replacing is not clear. Please help!

Read More
Abby -
January 04, 2016
See more answers